EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.
A-Tech
8GB DDR4 2133MHz CL15 desktop module replaces Samsung M378A1K43BB1-CPBD0 with 1.2V unbuffered operation
This 8GB DDR4 module runs at 2133MHz with CL15 latency and 1.2V operation. It is built as a compatible replacement for the Samsung M378A1K43BB1-CPBD0 part number. The unbuffered, non-ECC DIMM targets desktop users who need a direct swap for that specific Samsung stick.
The stick uses a standard 288-pin DDR4 DIMM layout, noted as 262-pin in the supplier data, and carries Samsung chipset components. No heat spreader is fitted, keeping the profile low for tight slots. Every unit passes A-Tech quality assurance testing before it ships.
Installation follows the usual desktop DIMM procedure: align the notch, press until the latches click, and verify the system POSTs at 2133MHz. The most frequent issue is a motherboard that defaults to a lower speed or fails to train when the slot population changes. Checking the manual for supported frequencies and seating the module firmly resolves most problems.
| Brand | A-Tech |
|---|---|
| Series | Compatible Replacement for Samsung |
| Model | M378A1K43BB1-CPBD0 |
| Capacity | 8GB |
| Speed | DDR4 2133 (PC4 17000) |
| Tested Frequency | 2133 |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Samsung Chipset |
| Heat Spreader | No |
| Features | M378A1K43BB1-CPBD0 |
| Recommend Use | Compatible Replacement for Samsung M378A1K43BB1-CPBD0 |
No heat spreader is fitted and the 1.20V DDR4 design runs within JEDEC thermal limits, so no aftermarket cooling is required.
The 2133 MT/s data rate is the hard ceiling; CL15 only adds a few nanoseconds per access and does not limit peak bandwidth.
At 1.20V the module typically draws 2–3 watts, producing minimal heat and negligible fan noise inside a desktop chassis.
Tudi v tem oddelku
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
V čem plačujete in v čem berete cene.
Poslano iz Vaše denarnice ob blagajni
Samo za prikaz — katalog je cenovno izražen v dolarjih
Nobena valuta ne ustreza.
Izberite jezik, v katerem Vam govori spletna stran.
Ni ustreznega jezika.
Prvič tu?
Že imate račun?
Samodejne ponastavitve ni: ta trgovina ne pošilja e-pošte, zato ni enkratne povezave, ki bi jo lahko zahtevali. Pustite naslov na računu — nekdo ga bo obravnaval ročno.
Zahteva zabeležena
V Vašo elektronsko pošto ne prihaja nič — ta trgovina ne pošilja nobene e-pošte. Zahteve nekdo obravnava ročno.
Ste se spomnili?