Computer Memory Solutions
Computer Memory Solutions 16GB (2x8GB) DDR3 1600MHz memory upgrade
16 GB dual-channel DDR3 kit (2 × 8 GB) at 1600 MHz, CL11, 1.5 V, validated for HP ProDesk 600 G1 Microtower
- Capacity16GB (2 x 8GB)
- Type240-Pin DDR3 SDRAM
- SpeedDDR3 1600 (PC3 12800)
- CAS LatencyCL11
- Timing11-11-11
- Voltage1.5V
- 16 GB dual-channel kit upgrades ProDesk 600 G1 Microtower
- DDR3 1600 MHz CL11 timing matches system bus speed
- 2 × 8 GB unbuffered non-ECC DIMMs install in pairs
- 5 V standard voltage works without BIOS changes
- Lifetime warranty from Computer Memory Solutions backs compatibility
16GB DDR3 Kit for HP ProDesk 600 G1
This 16GB kit contains two 8GB DDR3 1600MHz modules built for the HP ProDesk 600 G1 Microtower. The 240-pin DIMMs are unbuffered, non-ECC and run at 1.5V with CL11 timings. Computer Memory Solutions validates each kit against the target platform to avoid incompatibility issues.
Capacity and headroom for the ProDesk 600 G1
The system accepts up to 32GB across four slots, so this 16GB kit leaves two slots open for a future upgrade to the maximum. The board runs memory at 1066MHz regardless of module rating, so the 1600MHz parts will operate at the lower bus speed. A 64-bit operating system is required to address the full capacity.
Thermals noise and power in normal use
The modules have no heat spreaders and draw 1.5V, matching the standard DDR3 voltage for low thermal output inside the Microtower chassis. Passive cooling relies on case airflow, which is sufficient for typical office workloads. No moving parts means silent operation under all load conditions.
Poudarki
- 16 GB dual-channel kit upgrades ProDesk 600 G1 Microtower
- DDR3 1600 MHz CL11 timing matches system bus speed
- 2 × 8 GB unbuffered non-ECC DIMMs install in pairs
- 5 V standard voltage works without BIOS changes
- Lifetime warranty from Computer Memory Solutions backs compatibility
Specifikacije
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM10246412800DIMM |
| Capacity | 16GB (2 x 8GB) |
| Type | 240-Pin DDR3 SDRAM |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| Timing | 11-11-11 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Hp/Compaq Prodesk 600 G1 Series Microtower |
| Package Content | 2 Memory RAM Sticks |
Vprašanja o tem izdelku
Will this 16GB DDR3-1600 kit run at full speed alongside the 1066MHz memory bus in my ProDesk 600 G1 Microtower?
The system memory bus runs at 1066MHz per HP documentation, so these DDR3-1600 modules will operate at that lower speed when installed.
How can I confirm the dual-channel 16GB configuration is active after installing both 8GB sticks?
Enter the BIOS or use a system information tool; it should report 16GB total memory running in dual-channel mode at 1066MHz.
Does the package include only the two 240-pin DIMMs or are any installation tools or cables supplied?
The box contains two 8GB DDR3 240-pin DIMM modules; no tools, cables or additional hardware are included.
Tudi v tem oddelku
Stranke so primerjale tudi te
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.



