Acceptăm criptomonede — astfel, criptomonedele pe care le dețineți pot cumpăra echipamente reale.Plătiți în cripto, cheltuiți-o pe echipamente reale. Livrare asigurată gratuită oriunde în lume peste 399 $. Cartoane neutre, fără marcă, expediate din Germania.Livrare asigurată gratuită peste 399 $. Cursul dumneavoastră este blocat timp de 30 de minute de la deschiderea paginii de plată.Curs blocat 30 de minute. Fiecare articol este sigilat, numărul de serie este verificat, iar produsul este acoperit de o garanție de 24 de luni.Sigilat, garantat 24 de luni.

Produse urmărite Conectare
Two green DDR3 DIMM sticks, no heat spreaders

Computer Memory Solutions

Computer Memory Solutions 16GB (2x8GB) DDR3 1600MHz memory upgrade

SKU CH-CC8S-478GX

16 GB dual-channel DDR3 kit (2 × 8 GB) at 1600 MHz, CL11, 1.5 V, validated for HP ProDesk 600 G1 Microtower

  • Capacity16GB (2 x 8GB)
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Timing11-11-11
  • Voltage1.5V
  • 16 GB dual-channel kit upgrades ProDesk 600 G1 Microtower
  • DDR3 1600 MHz CL11 timing matches system bus speed
  • 2 × 8 GB unbuffered non-ECC DIMMs install in pairs
  • 5 V standard voltage works without BIOS changes
  • Lifetime warranty from Computer Memory Solutions backs compatibility

16GB DDR3 Kit for HP ProDesk 600 G1

This 16GB kit contains two 8GB DDR3 1600MHz modules built for the HP ProDesk 600 G1 Microtower. The 240-pin DIMMs are unbuffered, non-ECC and run at 1.5V with CL11 timings. Computer Memory Solutions validates each kit against the target platform to avoid incompatibility issues.

Capacity and headroom for the ProDesk 600 G1

The system accepts up to 32GB across four slots, so this 16GB kit leaves two slots open for a future upgrade to the maximum. The board runs memory at 1066MHz regardless of module rating, so the 1600MHz parts will operate at the lower bus speed. A 64-bit operating system is required to address the full capacity.

Thermals noise and power in normal use

The modules have no heat spreaders and draw 1.5V, matching the standard DDR3 voltage for low thermal output inside the Microtower chassis. Passive cooling relies on case airflow, which is sufficient for typical office workloads. No moving parts means silent operation under all load conditions.

Puncte forte

  • 16 GB dual-channel kit upgrades ProDesk 600 G1 Microtower
  • DDR3 1600 MHz CL11 timing matches system bus speed
  • 2 × 8 GB unbuffered non-ECC DIMMs install in pairs
  • 5 V standard voltage works without BIOS changes
  • Lifetime warranty from Computer Memory Solutions backs compatibility

Specificații

BrandComputer Memory Solutions
ModelCM10246412800DIMM
Capacity16GB (2 x 8GB)
Type240-Pin DDR3 SDRAM
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Timing11-11-11
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemHp/Compaq Prodesk 600 G1 Series Microtower
Package Content2 Memory RAM Sticks

Întrebări despre acest articol

Will this 16GB DDR3-1600 kit run at full speed alongside the 1066MHz memory bus in my ProDesk 600 G1 Microtower?

The system memory bus runs at 1066MHz per HP documentation, so these DDR3-1600 modules will operate at that lower speed when installed.

How can I confirm the dual-channel 16GB configuration is active after installing both 8GB sticks?

Enter the BIOS or use a system information tool; it should report 16GB total memory running in dual-channel mode at 1066MHz.

Does the package include only the two 240-pin DIMMs or are any installation tools or cables supplied?

The box contains two 8GB DDR3 240-pin DIMM modules; no tools, cables or additional hardware are included.

Tot din acest raion

Clienții au comparat și acestea.

Același raion, aceeași finalizare a comenzii — opt monede și un curs blocat 30 de minute.