Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
Four green DDR5 RDIMM modules in anti-static tray

NEMIX RAM

NEMIX RAM 256GB 4x64GB DDR5 5600 ECC RDIMM 2Rx4 CL46 1.1V GIGABYTE MZ73-LM2 memory upgrade

SKU CH-E02M-1F0RY

A 256GB kit of four 64GB DDR5 5600 registered ECC RDIMMs at CL46 1.1V, validated for the Gigabyte MZ73-LM2 motherboard

  • Capacity256GB (4 x 64GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 256GB 4X64GB

Prikaži še 24 konfiguracij
  • 256 GB capacity across four 64 GB modules for maximum server density
  • DDR5 5600 speed rated at CL46 latency for responsive data throughput
  • Registered ECC architecture with 2Rx4 organisation corrects single-bit errors automatically
  • 10 V operation matches the GIGABYTE MZ73-LM2 memory controller specification exactly
  • 288-pin RDIMM form factor installs directly into the board's DDR5 slots

256 GB DDR5-5600 ECC RDIMM kit

This 256 GB kit contains four 64 GB DDR5-5600 (PC5-44800) registered ECC RDIMMs. Each module is a 2Rx4 part running at 1.1 V with CL46 timing in the standard 288-pin form factor. It is built as an exact-match upgrade for the Gigabyte MZ73-LM2 motherboard.

Suited for servers needing maximum registered ECC

This kit suits administrators who must fully populate the MZ73-LM2 with registered ECC memory at the board's rated 5600 MT/s speed. It is not for systems that accept only unbuffered UDIMMs, for builds limited to lower total capacity, or for any board that does not support DDR5 RDIMMs.

Registered ECC RDIMM form factor decides fit

The memory controller on the MZ73-LM2 requires 288-pin registered ECC modules; unbuffered or non-ECC DIMMs will not work. Verify the motherboard manual for approved population order before installation.

Poudarki

  • 256 GB capacity across four 64 GB modules for maximum server density
  • DDR5 5600 speed rated at CL46 latency for responsive data throughput
  • Registered ECC architecture with 2Rx4 organisation corrects single-bit errors automatically
  • 10 V operation matches the GIGABYTE MZ73-LM2 memory controller specification exactly
  • 288-pin RDIMM form factor installs directly into the board's DDR5 slots

Specifikacije

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-924K4
Capacity256GB (4 x 64GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content256GB 4X64GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Druge različice tega modela

še 5 v isti paleti

Ista družina, različen pomnilnik, hladilnik ali takt — primerjajte, preden se odločite.

Vprašanja o tem izdelku

Does the GIGABYTE MZ73-LM2 motherboard need any specific BIOS setting to recognise the 256GB 4x64GB DDR5 5600 ECC RDIMM kit?

The kit is validated for the MZ73-LM2 at DDR5 5600 CL46 1.1V. Install the four 288-pin RDIMMs in the slots indicated by the board manual; the memory controller will detect the 2Rx4 registered modules and run them at the rated speed without extra configuration.

Will these registered ECC RDIMMs work in the same server if I keep older unbuffered DDR5 UDIMMs in other slots?

No. The MZ73-LM2 requires registered RDIMMs; mixing registered and unbuffered modules is not supported and will prevent the system from posting.

How can I confirm the 256GB kit is running at DDR5 5600 with ECC active after installation?

Boot into the BIOS or use a hardware-info utility; it should report 5600 MT/s, CL46, 1.1V, 2Rx4 organisation and show ECC enabled for all four 64GB modules.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.