Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.

Spremljani izdelki Prijava
Black 80mm square ball-bearing fan, 32mm deep, two-wire 12V .24A

OEM Industries

OEM Industries AD0812MB-Y51 80mm Ball Bearing Fan

SKU CH-QGNN-11Q2H

80 mm ball-bearing case fan runs on 12 V at 0.24 A with a two-wire connection

  • ColorBlack
  • TypeFan only
  • Fan Size80mm
  • Bearing TypeBall
  • LEDNo
  • Ball-bearing design extends service life
  • 12 V 0.24 A draw keeps power use low
  • 80 mm frame fits tight server bays
  • Two-wire lead simplifies wiring
  • Black finish suits clean builds

80mm 12V Ball Bearing Fan

The AD0812MB-Y51 is an 80mm square fan with a 32mm thickness. It runs on 12 volts and draws 0.24 amps through a two-wire connection. The ball bearing is built for continuous operation in servers and workstations. No LED lighting is included.

Suited for 80mm two-pin headers only

This unit fits chassis and coolers that accept an 80mm frame and a two-pin power header. It is not for builds that need PWM speed control or a three or four-pin connector. Buyers who need variable fan curves should look elsewhere.

Two-wire 12V 0.24A power spec

The fan uses a simple two-wire 12 volt input rated at 0.24 amps. This single electrical interface decides whether it matches your header. Verify the header type before ordering.

Poudarki

  • Ball-bearing design extends service life
  • 12 V 0.24 A draw keeps power use low
  • 80 mm frame fits tight server bays
  • Two-wire lead simplifies wiring
  • Black finish suits clean builds

Specifikacije

ModelAD0812MB-Y51
ColorBlack
TypeFan only
Fan Size80mm
Bearing TypeBall
LEDNo

Vprašanja o tem izdelku

What power connector does the AD0812MB-Y51 need?

The fan uses a 2-wire lead that connects to a standard 12 V fan header on the motherboard or controller.

Will the 80 mm frame fit the same mounting holes as my existing 8032 cooler?

Yes, the 80x32 mm dimensions match the industry-standard 8032 footprint, so existing screw holes line up.

How can I confirm the ball-bearing fan is spinning correctly after install?

Power the system and verify the blades rotate smoothly; the 12 V 0.24 A rating means the fan should reach full speed immediately.

Tudi v tem oddelku

Stranke so primerjale tudi te

Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.