We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 80mm square ball-bearing fan, 32mm deep, two-wire 12V .24A

OEM Industries

OEM Industries AD0812MB-Y51 80mm Ball Bearing Fan

SKU CH-QGNN-11Q2H

80 mm ball-bearing case fan runs on 12 V at 0.24 A with a two-wire connection

  • ColorBlack
  • TypeFan only
  • Fan Size80mm
  • Bearing TypeBall
  • LEDNo
  • Ball-bearing design extends service life
  • 12 V 0.24 A draw keeps power use low
  • 80 mm frame fits tight server bays
  • Two-wire lead simplifies wiring
  • Black finish suits clean builds

80mm 12V Ball Bearing Fan

The AD0812MB-Y51 is an 80mm square fan with a 32mm thickness. It runs on 12 volts and draws 0.24 amps through a two-wire connection. The ball bearing is built for continuous operation in servers and workstations. No LED lighting is included.

Suited for 80mm two-pin headers only

This unit fits chassis and coolers that accept an 80mm frame and a two-pin power header. It is not for builds that need PWM speed control or a three or four-pin connector. Buyers who need variable fan curves should look elsewhere.

Two-wire 12V 0.24A power spec

The fan uses a simple two-wire 12 volt input rated at 0.24 amps. This single electrical interface decides whether it matches your header. Verify the header type before ordering.

Highlights

  • Ball-bearing design extends service life
  • 12 V 0.24 A draw keeps power use low
  • 80 mm frame fits tight server bays
  • Two-wire lead simplifies wiring
  • Black finish suits clean builds

Specifications

ModelAD0812MB-Y51
ColorBlack
TypeFan only
Fan Size80mm
Bearing TypeBall
LEDNo

Questions about this item

What power connector does the AD0812MB-Y51 need?

The fan uses a 2-wire lead that connects to a standard 12 V fan header on the motherboard or controller.

Will the 80 mm frame fit the same mounting holes as my existing 8032 cooler?

Yes, the 80x32 mm dimensions match the industry-standard 8032 footprint, so existing screw holes line up.

How can I confirm the ball-bearing fan is spinning correctly after install?

Power the system and verify the blades rotate smoothly; the 12 V 0.24 A rating means the fan should reach full speed immediately.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.