OEM Industries
OEM Industries SUNON 6038 PMD1206PMB1-A 12V 10.6W 3-Wire CPU cooler
A 60 mm square fan with dual ball bearings and a 3-pin connector draws 10.6 W at 12 V
- ColorBlack
- TypeFan only
- Fan Size60mm
- Bearing Type2 Ball
- Power Connector3 Pin
- LEDNo
- 60 mm square frame fits tight spaces
- dual ball bearing extends operating life
- 12 V 10.6 W power draw for efficient cooling
- 3-pin connector enables speed monitoring
- 6038 form factor matches standard mounting holes
Compact 60mm square cooler
The OEM Industries SUNON 6038 PMD1206PMB1-A is a 60 by 38 millimetre fan-only cooler designed for small-form-factor systems or replacement of original-equipment units. It suits builders who need a direct 12 volt drop-in with a three-pin power connector and no integrated lighting.
Dual-ball bearing for continuous duty
The 2 ball bearing assembly is rated for sustained operation at 12 volts and 10.6 watts, resisting wear better than sleeve alternatives when the fan runs constantly. Steady airflow is maintained under load without the speed decay that can occur in shorter-life bearings.
Verify mounting holes and header type
Confirm that your board or chassis provides the 60mm square mounting pattern and a three-pin fan header before ordering. This unit lacks a four-pin PWM lead and RGB lighting, so systems requiring automatic speed curves or illuminated fans will need a different solution.
Poudarki
- 60 mm square frame fits tight spaces
- dual ball bearing extends operating life
- 12 V 10.6 W power draw for efficient cooling
- 3-pin connector enables speed monitoring
- 6038 form factor matches standard mounting holes
Specifikacije
| Model | PMD1206PMB1-A |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 60mm |
| Bearing Type | 2 Ball |
| Power Connector | 3 Pin |
| LED | No |
Vprašanja o tem izdelku
How much power does the 12 V 10.6 W SUNON 6038 fan draw when it runs continuously?
The fan is rated at 10.6 W at 12 V, so that is the steady-state power draw during all-day operation.
What motherboard header is required for the 3-pin power connector on this PMD1206PMB1-A cooler?
A standard 3-pin fan header on the motherboard or a compatible fan controller is needed to power and monitor the cooler.
Will the 60 mm square frame fit the mounting holes on my older 60 mm CPU cooler bracket?
The cooler uses a 60 mm square frame; if your existing bracket matches the 60 mm mounting pattern it will fit.
Tudi v tem oddelku
Stranke so primerjale tudi te
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
ModMyMods
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear
0,82 $
0.00001049BTC
Na zalogi