SanDisk
SanDisk Cruzer Blade 8 GB USB 2.0 USB flash drive Black SDCZ50-008G-B35
391,99 US$
0.00501657BTC
I lager
Computer Memory Solutions
Computer Memory Solutions CM10246412800SODRL 16GB (2 x 8GB) DDR3L 1600 CL11 1.35V SO-DIMM memory upgrade
A 16 GB DDR3L SO-DIMM kit of two 8 GB modules running at 1600 MHz CL11 and 1.35 V, validated for the HP EliteOne 800 G1 all-in-one desktop
- Capacity16GB (2 x 8GB)
- Type204-Pin DDR3 SO-DIMM
- SpeedDDR3L 1600 (PC3L 12800)
- CAS LatencyCL11
- Timing11-11-11
- Voltage1.35V
- 16 GB total capacity from two 8 GB modules
- DDR3L 1600 speed with CL11 timing for responsive performance
- 35 V low-voltage operation reduces power draw
- 204-pin SO-DIMM form factor fits the EliteOne 800 G1 All-In-One
- Guaranteed compatibility with listed HP part numbers
CMS 16GB DDR3L Kit for HP EliteOne 800 G1
This 16 GB kit contains two 8 GB DDR3L SO-DIMM modules rated at 1600 MHz with CL11 timings. It is built specifically for the HP/Compaq EliteOne 800 G1 All-In-One desktop. The unbuffered, non-ECC sticks operate at 1.35 V and use major-brand chipsets.
Check your EliteOne 800 G1 configuration before
The system supports a maximum of 16 GB across two 204-pin sockets. Verify that both slots are free or that you are replacing the existing pair. This kit fills the board to its limit, so no further expansion is possible after installation.
Replaces slower or smaller DDR3L sets
Upgrading from a 4 GB or 8 GB configuration removes the memory ceiling that limits multitasking and large workloads. The jump is worth it when the current amount forces frequent paging or prevents the applications you run from fitting in RAM.
I korthet
- 16 GB total capacity from two 8 GB modules
- DDR3L 1600 speed with CL11 timing for responsive performance
- 35 V low-voltage operation reduces power draw
- 204-pin SO-DIMM form factor fits the EliteOne 800 G1 All-In-One
- Guaranteed compatibility with listed HP part numbers
Specifikationer
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM10246412800SODRL |
| Capacity | 16GB (2 x 8GB) |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Timing | 11-11-11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Hp/Compaq Eliteone 800 G1 All-In-One Desktop |
| Package Content | 2 Memory RAM Sticks |
Frågor om den här produkten
Does the kit include both 8 GB modules or do I need to buy a second stick separately?
The package contains two 8 GB SO-DIMM modules, giving 16 GB total with no extra purchase required.
My EliteOne 800 G1 has two slots — should I use the full 16 GB kit or a single 8 GB module?
The system supports a maximum of 16 GB across its two sockets, so the 2 x 8 GB kit fills both slots and reaches that limit.
Will the 1600 MHz CL11 rating actually run at that speed once installed in the All-in-One?
The modules are rated for DDR3L 1600 at CL11 and 1.35 V; the EliteOne 800 G1 memory controller will operate them at those specifications.
Även i den här avdelningen
Andra har jämfört dessa
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
