DELL
DELL 480GB SATA 2.5" Enterprise SSD J1TYJ-CP1
480 GB SATA enterprise SSD for mixed-use workloads in Dell PowerEdge servers
- InterfaceSATA
- 480 GB capacity stores large datasets
- SATA 6 Gbps interface fits existing server bays
- Mixed-use TLC flash handles read and write workloads
- 7 mm 2.5 inch form factor slides into Dell PowerEdge chassis
- Tested components with updated firmware ensure reliable operation
480 GB SATA enterprise SSD
This 480 GB SATA solid-state drive is built for Dell PowerEdge servers that need reliable mixed-use storage. It fits 2.5-inch bays with a 7 mm height and uses TLC NAND for balanced read and write endurance. The drive targets administrators upgrading or maintaining compatible rack and tower platforms.
7 mm 2.5-inch form factor for hot-plug bays
The slim 7 mm profile slides directly into standard 2.5-inch hot-plug carriers without adapters. A SATA 6 Gbps connector provides the data and power path, so installation follows the usual caddyless or caddied workflow. Firmware is updated before shipment to match current Dell server requirements.
Low power draw and silent operation
With no moving parts the drive runs silently and draws minimal power during typical mixed-use workloads. Heat output stays low enough for dense server chassis without extra cooling attention. The TLC design delivers steady throughput for database, virtualization and logging tasks.
I korthet
- 480 GB capacity stores large datasets
- SATA 6 Gbps interface fits existing server bays
- Mixed-use TLC flash handles read and write workloads
- 7 mm 2.5 inch form factor slides into Dell PowerEdge chassis
- Tested components with updated firmware ensure reliable operation
Specifikationer
| Brand | Dell |
|---|---|
| Model | HFS480G32FEH-BA10A, J1TYJ |
| Interface | SATA |
Frågor om den här produkten
What practical throughput does the 6 Gbps SATA interface cap this drive at?
The 6 Gbps SATA link limits sequential throughput to roughly 560 MB/s read.
What physical space and mounting does the 7 mm 2.5 inch form factor require?
It fits a standard 2.5 inch bay with 7 mm height clearance and uses the usual SATA data and power connectors.
How is the drive installed in a PowerEdge server and what step is often missed?
Slide the drive into a hot-swap caddy until the connector seats, then lock the lever; the step often missed is fully engaging the latch so the drive registers.
Även i den här avdelningen
Andra har jämfört dessa
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
