SPARTAN 1-to-9 SATA HDD/SSD Duplicator H09HSHEB
- Hard Drive Duplicat…
- 1 to 9
Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.
DELL
A 4 TB 3.5" SAS internal hard drive spinning at 7200 RPM with hot-swap support for Dell EMC MD14xx storage enclosures
The Dell YXG4K is a 4TB 3.5 inch internal hard drive with a SAS 12Gb/s interface spinning at 7200 RPM. It is built for Dell EMC MD14xx enclosures and similar storage systems that require hot-swap capability. The drive uses SLC NAND flash memory for caching. It suits administrators expanding capacity in compatible Dell EMC storage platforms.
Installation slides the drive into a hot-swap bay until the carrier locks, requiring no cable routing inside the enclosure. The SAS 12Gb/s connector mates automatically with the backplane when the tray is fully seated. Problems arise when the enclosure firmware does not recognise the Dell part number YXG4K or when the backplane negotiates at a lower link speed than 12Gb/s. Mixing drives with different firmware revisions in the same virtual disk can also trigger rebuild errors.
Confirm the MD14xx enclosure lists part YXG4K on its qualified vendor list before ordering. Check that the backplane and controller support SAS 12Gb/s operation rather than an earlier 6Gb/s limit. Ensure an empty 3.5 inch hot-swap bay is available and that the RAID controller can address the 4TB capacity. The drive is not suited for direct attachment to a standard desktop motherboard lacking a SAS HBA.
| Brand | Dell |
|---|---|
| Model | YXG4K |
| Interface | SAS 12Gb/s |
| Capacity | 4TB |
| NAND Flash Memory Type | SLC |
| RPM | 7200 RPM |
| Form Factor | 3.5" |
Check the drive information in your RAID controller BIOS or operating system utilities; they will report the spindle speed and negotiated SAS link rate.
The drive ships in retail or OEM packaging; no caddy, screws or cables are included, so you must supply a compatible 3.5" hot-swap tray for your enclosure.
This 4TB SAS 12Gb/s model is the listed part for MD14xx systems; select it when you need 4TB of 7200 RPM storage in that chassis.
Även i den här avdelningen
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
Det du betalar med, och det du ser priserna i.
Skickas från din plånbok i kassan
Endast visning — katalogen är prissatt i US-dollar
Ingen valuta matchar.
Välj det språk du vill att webbplatsen ska visas på.
Inga språk matchar.
Ny här?
Har du redan ett konto?
Det finns ingen automatisk återställning: den här butiken skickar inga e-postmeddelanden, så det finns ingen engångslänk att begära. Lämna adressen kopplad till kontot, så hanteras den för hand.
Förfrågan noterad
Inget är på väg till din inkorg — den här butiken skickar aldrig e-post. Någon tar hand om detta manuellt.
Kom du på det?