Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.

Bevakade produkter Logga in
Rectangular black ATX power supply unit with label showing 56V 0.17A 80W

KHACHIMO

KHACHIMO POE80U-560(G)-C-R 56V 0.17A 80W power supply

SKU CH-APC3-T1WX5

An 80 W ATX power supply delivering 56 V at 0.17 A for Cisco switches

  • TypeATX
  • 56 V output powers compatible Cisco PoE switches
  • 80 W capacity delivers reliable energy for network gear
  • 17 A current rating matches original equipment specs
  • Tested working to confirm correct operation before use

Cisco 56V 80W ATX power supply

This ATX power supply delivers 56 volts at 0.17 amps for a total of 80 watts. It is built to power Cisco networking equipment that requires a 56V DC input. The unit is supplied new and has been tested for correct operation. It suits administrators replacing a failed POE80U-560(G)-C-R module in compatible switches.

Thermals noise and power draw

The 80 watt output defines the maximum heat the supply must dissipate under load. Fan speed and acoustic output will vary with the host chassis airflow design rather than the supply alone. Power drawn from the mains will be slightly above 80 watts to cover conversion losses. No independent noise or efficiency figures are provided for this model.

I korthet

  • 56 V output powers compatible Cisco PoE switches
  • 80 W capacity delivers reliable energy for network gear
  • 17 A current rating matches original equipment specs
  • Tested working to confirm correct operation before use

Specifikationer

TypeATX

Frågor om den här produkten

How do I install this 80 W power supply into a Cisco PoE switch without damaging the 56 V connector?

Slide the unit firmly into the switch bay until the latch clicks, then tighten the captive screws; the step most people skip is seating the connector fully before screwing it down, which prevents bent pins on the 56 V rail.

What maintenance will the POE80U-560(G)-C-R need after extended 0.17 A operation?

Clean the intake vents every six months with compressed air to stop dust buildup; the internal fan bearings are rated for continuous duty, so no scheduled replacement is required unless noise or vibration appears.

Även i den här avdelningen

Andra har jämfört dessa

Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.