Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.

Bevakade produkter Logga in
Four green DDR5 UDIMM modules with black chips no heat spreaders

NEMIX RAM

NEMIX RAM 32GB (4x8GB) DDR5 4800 CL40 1.1V UDIMM Kit for Supermicro X14SAE

SKU CH-SK17-ZN3D2

A 32GB kit of four 8GB DDR5-4800 CL40 UDIMMs built for the Supermicro X14SAE motherboard

  • Capacity32GB (4 x 8GB)
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCNo

Size 32GB 4X8GB

  • Exact-match 32 GB kit runs at DDR5 4800 CL40 1.1 V for full rated speed
  • Verified fit for Supermicro X14SAE with 288-pin UDIMM form factor
  • Major OEM chips from Samsung Micron Hynix tested at rated specs
  • 4 x 8 GB 1Rx8 modules populate board slots per population rules
  • Lifetime replacement warranty with US-based technical support included

Capacity and compatibility

This 32 GB kit contains four 8 GB DDR5 UDIMMs validated for the Supermicro X14SAE motherboard. It delivers the exact rank, voltage and timing the board's memory controller expects for full-capacity recognition.

Upgrade scope

The kit replaces any smaller or mismatched DDR5 UDIMM population on the X14SAE. The jump is worthwhile when the current configuration limits multitasking headroom or leaves DIMM slots unfilled on this platform.

DDR5-4800 limits

At the JEDEC DDR5-4800 standard the modules operate at 1.1 V with CL40 latency and 1Rx8 organisation. Bandwidth and latency are fixed by this specification; higher throughput requires a motherboard and processor that support faster DDR5 data rates.

I korthet

  • Exact-match 32 GB kit runs at DDR5 4800 CL40 1.1 V for full rated speed
  • Verified fit for Supermicro X14SAE with 288-pin UDIMM form factor
  • Major OEM chips from Samsung Micron Hynix tested at rated specs
  • 4 x 8 GB 1Rx8 modules populate board slots per population rules
  • Lifetime replacement warranty with US-based technical support included

Specifikationer

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD38400-818K4
Capacity32GB (4 x 8GB)
Type288-Pin DDR5 UDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB 4X8GB DDR5 4800MHz PC5-38400 1Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Andra versioner av den här modellen

5 till i samma serie

Samma familj, men olika minne, kylning eller klockfrekvens — jämför innan du bestämmer dig.

Frågor om den här produkten

Does the 288-pin DDR5 UDIMM kit fit the Supermicro X14SAE motherboard slots?

The kit uses the exact 288-pin DDR5 UDIMM form factor required by the Supermicro X14SAE, so each of the four 8 GB modules seats directly in the board's DIMM slots without adapters.

What is the correct installation order for the four 8 GB modules on the X14SAE?

Populate the slots in the sequence listed in the motherboard manual — typically the first and third slots for a two-module start, then add the remaining two — so the memory controller recognises the full 32 GB at DDR5-4800 CL40.

Will the modules need a firmware update or active cooling later?

No firmware updates apply to UDIMMs and the kit has no heat spreader; standard case airflow is sufficient, and the modules are rated for lifetime operation at 1.1 V with no scheduled replacement.

Även i den här avdelningen

Andra har jämfört dessa

Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.