Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.

Bevakade produkter Logga in

NEMIX RAM

NEMIX RAM DDR5 4800 1.1TB 12x96GB CL40 2Rx4 ECC RDIMM GIGABYTE MZ33-CP1

SKU CH-9GAM-90W8A

1.1TB DDR5 server memory kit with twelve 96GB registered ECC RDIMMs at 4800MHz CL40 for GIGABYTE MZ33-CP1 motherboards

  • Capacity1.1TB (12 x 96GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes
  • 1TB capacity across 12 modules of 96GB each
  • DDR5 4800 speed with PC5-38400 bandwidth rating
  • CL40 latency at 1.10V operating voltage
  • 2Rx4 registered ECC architecture for error correction
  • 288-pin RDIMM form factor matched to GIGABYTE MZ33-CP1

1.1 TB DDR5-4800 ECC RDIMM kit

This 1.1 TB kit contains twelve 96 GB DDR5-4800 Registered ECC RDIMMs built to the PC5-38400 standard at 1.10 V and CL40. It is a system-specific upgrade designed for the GIGABYTE MZ33-CP1 motherboard where the memory controller expects this exact rank, voltage and timing configuration.

Suited for fully populated MZ33-CP1 servers

The 2Rx4 Registered design offloads the memory controller so every slot runs at full capacity while ECC corrects single-bit errors on the fly. Builders who need unbuffered UDIMMs, SODIMMs, non-ECC modules or a smaller total capacity should look at something else.

Twelve 96 GB modules at DDR5-4800

The kit delivers 1.1 TB of addressable memory across all twelve channels, providing headroom for large virtualisation clusters, in-memory databases and heavy compute workloads. It runs out when the workload exceeds the board's maximum supported density or requires speeds higher than 4800 MT/s.

I korthet

  • 1TB capacity across 12 modules of 96GB each
  • DDR5 4800 speed with PC5-38400 bandwidth rating
  • CL40 latency at 1.10V operating voltage
  • 2Rx4 registered ECC architecture for error correction
  • 288-pin RDIMM form factor matched to GIGABYTE MZ33-CP1

Specifikationer

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-9624K12
Capacity1.1TB (12 x 96GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content1.1TB 12X96GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Andra versioner av den här modellen

5 till i samma serie

Samma familj, men olika minne, kylning eller klockfrekvens — jämför innan du bestämmer dig.

Frågor om den här produkten

Do I need a GIGABYTE MZ33-CP1 motherboard with 12 free DDR5 RDIMM slots to install this 1.1TB kit?

Yes, the kit is built for the GIGABYTE MZ33-CP1 and requires 12 available 288-pin DDR5 RDIMM slots to reach the full 1.1TB capacity at DDR5-4800.

Will these CL40 2Rx4 Registered ECC modules run at DDR5-4800 alongside older DDR5-4800 RDIMMs I already have?

Mixing ranks or timings can prevent the memory controller from training at the rated DDR5-4800 speed; populate all 12 slots with this matched 2Rx4 CL40 kit for guaranteed operation.

How do I confirm the server sees all 1.1TB at CL40 1.10V after installation?

Enter the BIOS and verify the memory information shows 12 modules detected, 1.1TB total, DDR5-4800 frequency, CL40 timings and 1.10V voltage.

Även i den här avdelningen

Andra har jämfört dessa

Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.