Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.

Bevakade produkter Logga in
Black 60mm square CPU cooler fan 13mm thick with three wire connector

OEM Industries

OEM Industries ABB06D12HG 60mm 13mm 12V 0.3A CPU Cooler Fan

SKU CH-8Y2P-QKC64

A 60 mm ball-bearing fan with a 3-pin or 4-pin connector runs on 12 V and draws 0.3 A

  • ColorBlack
  • TypeFan only
  • Fan Size60mm
  • Bearing TypeBall
  • Power Connector3 / 4 Pin
  • LEDNo
  • 60 mm fan fits compact CPU coolers
  • Ball bearing extends operational life
  • 12 V 0.3 A draws minimal power
  • 3 / 4 pin connector suits most headers
  • 13 mm slim profile clears tight spaces

60 mm Replacement Fan

The ABB06D12HG is a 60 mm fan designed for CPU air coolers that use this frame size and a 12 V supply. It suits system builders or repair technicians who need a direct drop-in part for an existing heatsink assembly. The black finish and absence of LEDs keep the appearance neutral inside any chassis. It connects with a standard three or four pin power connector.

Ball Bearing Upgrade

This unit uses a ball bearing instead of a sleeve bearing, giving longer service life and more consistent speed under continuous load. The change is worth it when the original fan has become noisy, has slowed down, or has stopped spinning entirely. The 12 V 0.3 A rating matches many OEM coolers, so no controller change is required. It replaces only the fan, not the heatsink or mounting hardware.

13 mm Thick Air Mover

At 13 mm thick the fan fits coolers built for that profile and delivers airflow suited to low profile or compact tower heatsinks. It comfortably handles typical office or home office thermal loads where the original cooler was adequate. It runs out of capacity on high TDP processors or in tightly packed cases where static pressure requirements exceed what a 60 mm frame can provide.

I korthet

  • 60 mm fan fits compact CPU coolers
  • Ball bearing extends operational life
  • 12 V 0.3 A draws minimal power
  • 3 / 4 pin connector suits most headers
  • 13 mm slim profile clears tight spaces

Specifikationer

ModelABB06D12HG
ColorBlack
TypeFan only
Fan Size60mm
Bearing TypeBall
Power Connector3 / 4 Pin
LEDNo

Frågor om den här produkten

Will the 60mm frame and 13mm thickness fit my CPU cooler mounting holes?

The fan measures 60mm square and 13mm thick, so it matches coolers designed for that exact footprint.

How do I connect the 3-pin or 4-pin header without reversing the polarity?

Align the keyed notch on the connector with the motherboard header tab; the 3-pin plug fits a 4-pin header by leaving the fourth pin empty.

When should I expect to replace the ball-bearing fan?

Ball bearings typically run for tens of thousands of hours; replace the fan if noise increases or speed drops below spec.

Även i den här avdelningen

Andra har jämfört dessa

Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.