NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
Brute Networks
Dell-compatible 16GB DDR4-2133 registered ECC RDIMM upgrades server memory capacity with CL15 timing and 1.2V operation
This 16GB DDR4-2133 registered DIMM is built for Dell servers that require ECC memory with a 2Rx4 organisation. It operates at 1.20V with a CAS latency of 15 and fits standard 288-pin DDR4 slots. The module uses major-brand DRAM chips and is validated as 100% compatible with Dell part number RDWTP.
Registered buffering reduces electrical load on the memory controller, allowing the module to sustain its rated DDR4-2133 speed under continuous multi-threaded demand. ECC detection corrects single-bit errors on the fly, preventing the silent data corruption that can accumulate during long-running database or virtualisation tasks. The 2Rx4 rank layout keeps signal integrity stable when all slots are populated.
Installation follows standard RDIMM procedure: power down, open the chassis, align the notch with the 288-pin key and press until the retention clips engage. The module will not function in platforms that require unbuffered UDIMMs or load-reduced LRDIMMs, so buyers must confirm their server specifies registered memory. Mixing ranks or speeds across channels can prevent the system from posting.
| Brand | Dell |
|---|---|
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
The module operates at 1.20V, the standard voltage for DDR4, so power consumption stays within normal DDR4 limits for a 16GB registered DIMM under sustained load.
Yes, the system must accept 288-pin DDR4 registered RDIMMs with ECC; the stick is 2Rx4 CL15 at 2133 MT/s and requires a compatible chipset and BIOS.
All populated slots will run at the lowest common speed and latency; adding this 2133 MT/s CL15 module alongside slower DDR4 will down-clock the new stick to match.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?