NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar imot kryptovaluta — slik kan kryptovalutaene du eier, kjøpe ekte maskinvare.Betal med krypto, bruk den på ekte maskinvare. Gratis, forsikret levering verden over for bestillinger over 399 $. Nøytrale kartonger uten merking, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Kursen din er låst i 30 minutter når kassen åpnes.Kurs låst i 30 minutter. Alle varer er forseglet, serienummerkontrollert og dekket av 24 måneders garanti.Forseglet, 24 måneders garanti.
Brute Networks
Dell-compatible 16GB DDR4-2133 registered ECC RDIMM upgrades server memory capacity with CL15 timing and 1.2V operation
This 16GB DDR4-2133 registered DIMM is built for Dell servers that require ECC memory with a 2Rx4 organisation. It operates at 1.20V with a CAS latency of 15 and fits standard 288-pin DDR4 slots. The module uses major-brand DRAM chips and is validated as 100% compatible with Dell part number RDWTP.
Registered buffering reduces electrical load on the memory controller, allowing the module to sustain its rated DDR4-2133 speed under continuous multi-threaded demand. ECC detection corrects single-bit errors on the fly, preventing the silent data corruption that can accumulate during long-running database or virtualisation tasks. The 2Rx4 rank layout keeps signal integrity stable when all slots are populated.
Installation follows standard RDIMM procedure: power down, open the chassis, align the notch with the 288-pin key and press until the retention clips engage. The module will not function in platforms that require unbuffered UDIMMs or load-reduced LRDIMMs, so buyers must confirm their server specifies registered memory. Mixing ranks or speeds across channels can prevent the system from posting.
| Brand | Dell |
|---|---|
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
The module operates at 1.20V, the standard voltage for DDR4, so power consumption stays within normal DDR4 limits for a 16GB registered DIMM under sustained load.
Yes, the system must accept 288-pin DDR4 registered RDIMMs with ECC; the stick is 2Rx4 CL15 at 2133 MT/s and requires a compatible chipset and BIOS.
All populated slots will run at the lowest common speed and latency; adding this 2133 MT/s CL15 module alongside slower DDR4 will down-clock the new stick to match.
Også i denne avdelingen
Samme hylle, samme kasse — åtte mynter og 30 minutters kurslås.
Det du betaler med, og det du ser prisene i.
Sendes fra lommeboken din i kassen
Kun visning — katalogen er prissatt i USD
Fant ingen valuta.
Velg språket nettstedet snakker til deg på.
Ny her?
Har du allerede en konto?
Det finnes ingen automatisk tilbakestilling: butikken sender ikke e-post, så det finnes ingen engangslenke å be om. La adressen stå på kontoen, så blir den behandlet manuelt.
Forespørsel registrert
Ingenting er på vei til innboksen din — butikken sender ingen e-post i det hele tatt. Noen behandler dette manuelt.
Husket du det likevel?