Green 260-pin DDR4 SODIMM module, 16GB capacity

NEMIX RAM

NEMIX RAM 16GB DDR4 3200 CL22 2Rx8 260-Pin SODIMM for POSIFLEX EK-2132

SKU CH-NDSS-S4PJG

16GB DDR4 3200 CL22 2Rx8 260-Pin SODIMM built for POSIFLEX EK-2132 kiosks

Capacity16GB
SpeedDDR4 3200 (PC4 25600)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V

16GB DDR4 3200 SODIMM upgrades POSIFLEX EK-2132 kiosk performance
CL22 1.2V operation keeps power draw low in compact terminals
2Rx8 260-pin layout matches factory slot specification exactly
Samsung Micron Hynix chipset ensures stable mission-critical uptime
Non-ECC unbuffered design installs in minutes with no configuration needed

90,99 щ.д.

0.00118543 BTC по днешния курс

В наличност · изпраща се днес

На касата курсът се заключва за 30 минути.

Доставка до Съединени щати ориентировъчно

UPS Worldwide Expedited 3–6 работни дни 39,90 щ.д.
DHL Express Worldwide 2–3 работни дни 74,90 щ.д.

Добавете още 308,01 щ.д. и стандартната доставка става безплатна.

Вносните мита се начисляват от Вашата държава при пристигане.

Доставка на друг адрес

POSIFLEX EK-2132 Compatible SODIMM

This 16 GB DDR4 3200 module is built specifically for the POSIFLEX EK-2132 Mercury Series kiosk. It uses a 260-pin SODIMM form factor with CL22 latency and 1.2 V operation. The single stick delivers 16 GB in a 2Rx8 layout without ECC or a heat spreader.

Upgrade from lower capacity or slower DDR4

Replacing a smaller or slower DDR4 SODIMM with this 16 GB PC4-25600 unit adds headroom for multi-tasking and POS workloads. The jump is worthwhile when the kiosk currently runs 8 GB or a lower speed grade and the board accepts 3200 MT/s modules.

Verify slot count and maximum supported memory

Confirm the EK-2132 has a free SODIMM slot or that you are replacing the only installed stick. Check the system manual for the maximum total memory and supported rank configuration before ordering.

Акценти

16GB DDR4 3200 SODIMM upgrades POSIFLEX EK-2132 kiosk performance
CL22 1.2V operation keeps power draw low in compact terminals
2Rx8 260-pin layout matches factory slot specification exactly
Samsung Micron Hynix chipset ensures stable mission-critical uptime
Non-ECC unbuffered design installs in minutes with no configuration needed

Спецификации

Brand	NEMIX RAM
Series	POSIFLEX POS Series Point of Sale Kiosk Memory
Model	POSIFLEX POS DDR4 3200MHZ Non-ECC Unbuffered SODIMM
Part Number	MS25600-628K1
Capacity	16GB
Speed	DDR4 3200 (PC4 25600)
ECC	No
Buffered/Registered	Unbuffered
Chipset	Major OEM Samsung, Micron, Hynix
Voltage	1.20V
Compatible System	POSIFLEX POS
CAS Latency	CL22
Heat Spreader	No
Type	260-Pin DDR4 SODIMM
Rank	2Rx8
Features	DDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible
Package Content	16GB (1X16GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 260-PIN Non-ECC Unbuffered SODIMM

Въпроси за този артикул

Does this 260-pin DDR4 SODIMM fit the POSIFLEX EK-2132 memory slot?

Yes, the module is a 260-pin DDR4 SODIMM built to the PC4-25600 standard and validated for the POSIFLEX EK-2132 Mercury Series kiosk.

How do I install this 16 GB stick, and what step is often missed?

Power off the kiosk, open the memory door, align the notch on the 260-pin edge connector, press firmly until both side clips snap shut, then confirm 16 GB appears in BIOS before closing the case.

Will the Samsung, Micron or Hynix chips on this module need replacement or special care later?

No scheduled maintenance is required; the chips are stress-tested at 1.2 V and CL22, and the module carries a lifetime replacement warranty if a fault ever develops.

Още от този рафт