BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 US$
0.00278882BTC
I lager
NEMIX RAM
NEMIX RAM 16GB DDR4 3200 CL22 2Rx8 260-Pin SODIMM for POSIFLEX EK-2132
16GB DDR4 3200 CL22 2Rx8 260-Pin SODIMM built for POSIFLEX EK-2132 kiosks
- Capacity16GB
- SpeedDDR4 3200 (PC4 25600)
- ECCNo
- Buffered/RegisteredUnbuffered
- ChipsetMajor OEM Samsung, Micron, Hynix
- Voltage1.20V
- 16GB DDR4 3200 SODIMM upgrades POSIFLEX EK-2132 kiosk performance
- CL22 1.2V operation keeps power draw low in compact terminals
- 2Rx8 260-pin layout matches factory slot specification exactly
- Samsung Micron Hynix chipset ensures stable mission-critical uptime
- Non-ECC unbuffered design installs in minutes with no configuration needed
POSIFLEX EK-2132 Compatible SODIMM
This 16 GB DDR4 3200 module is built specifically for the POSIFLEX EK-2132 Mercury Series kiosk. It uses a 260-pin SODIMM form factor with CL22 latency and 1.2 V operation. The single stick delivers 16 GB in a 2Rx8 layout without ECC or a heat spreader.
Upgrade from lower capacity or slower DDR4
Replacing a smaller or slower DDR4 SODIMM with this 16 GB PC4-25600 unit adds headroom for multi-tasking and POS workloads. The jump is worthwhile when the kiosk currently runs 8 GB or a lower speed grade and the board accepts 3200 MT/s modules.
Verify slot count and maximum supported memory
Confirm the EK-2132 has a free SODIMM slot or that you are replacing the only installed stick. Check the system manual for the maximum total memory and supported rank configuration before ordering.
I korthet
- 16GB DDR4 3200 SODIMM upgrades POSIFLEX EK-2132 kiosk performance
- CL22 1.2V operation keeps power draw low in compact terminals
- 2Rx8 260-pin layout matches factory slot specification exactly
- Samsung Micron Hynix chipset ensures stable mission-critical uptime
- Non-ECC unbuffered design installs in minutes with no configuration needed
Specifikationer
| Brand | NEMIX RAM |
|---|---|
| Series | POSIFLEX POS Series Point of Sale Kiosk Memory |
| Model | POSIFLEX POS DDR4 3200MHZ Non-ECC Unbuffered SODIMM |
| Part Number | MS25600-628K1 |
| Capacity | 16GB |
| Speed | DDR4 3200 (PC4 25600) |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Voltage | 1.20V |
| Compatible System | POSIFLEX POS |
| CAS Latency | CL22 |
| Heat Spreader | No |
| Type | 260-Pin DDR4 SODIMM |
| Rank | 2Rx8 |
| Features | DDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible |
| Package Content | 16GB (1X16GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 260-PIN Non-ECC Unbuffered SODIMM |
Frågor om den här produkten
Does this 260-pin DDR4 SODIMM fit the POSIFLEX EK-2132 memory slot?
Yes, the module is a 260-pin DDR4 SODIMM built to the PC4-25600 standard and validated for the POSIFLEX EK-2132 Mercury Series kiosk.
How do I install this 16 GB stick, and what step is often missed?
Power off the kiosk, open the memory door, align the notch on the 260-pin edge connector, press firmly until both side clips snap shut, then confirm 16 GB appears in BIOS before closing the case.
Will the Samsung, Micron or Hynix chips on this module need replacement or special care later?
No scheduled maintenance is required; the chips are stress-tested at 1.2 V and CL22, and the module carries a lifetime replacement warranty if a fault ever develops.
Även i den här avdelningen
Andra har jämfört dessa
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
