NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Приемаме криптовалута — така монетите, които притежавате, могат да купят истински хардуер.Платете с крипто, похарчете го за истински хардуер. Безплатна застрахована доставка по целия свят над 399 $. Неутрални кашони без марка, изпратени от Германия.Безплатна застрахована доставка над 399 $. Курсът Ви е заключен за 30 минути веднага след отварянето на касата.Курс, заключен за 30 минути. Всеки артикул е запечатан, серийният му номер е проверен, и е покрит с 24-месечна гаранция.Запечатан, 24-месечна гаранция.
Replace Power
420W ATX power supply with SATA and dual ATX connectors for Compaq Presario desktops
The Replace Power RPSU-C99-41 is a 420W ATX unit built to match the original power module in Compaq Presario SR2013WM, SR2014HM, SR2015LA, SR2017CL and SR2017LA desktops. It delivers the exact wattage and form factor required by those systems. Builders working on other platforms or needing higher output should look elsewhere.
The grey chassis holds a single fan and supplies a fixed harness: one 15-inch SATA connector, one 14-inch ATX connector compatible with both 20-pin and 24-pin motherboards, one 14-inch 12V ATX connector, two 15-inch large power connectors, two 6-inch large power connectors and one 6-inch small power connector. Cable lengths are set, so routing space inside the case must accommodate the listed reaches.
Rated at 420W, the supply uses one fan to move air through the grey enclosure under normal load. Acoustic output and thermal behaviour follow the single-fan design at this wattage level. No modular cabling or alternative cooling modes are provided.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-41 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
It supplies one 15-inch SATA connector, one 14-inch ATX connector supporting both 20-pin and 24-pin layouts, one 14-inch 12V ATX connector, two 15-inch large power connectors, two 6-inch large power connectors and one 6-inch small power connector.
The unit follows the standard ATX form factor and is listed as a direct replacement for the SR2013WM, SR2014HM, SR2015LA, SR2017CL and SR2017LA models, so it mounts in the same bay with the same screw pattern.
Fit the unit into the case and secure the screws, then plug the 14-inch ATX connector into the motherboard (20-pin or 24-pin), attach the 14-inch 12V ATX cable, connect the SATA lead to drives, and finally add the large and small peripheral connectors as needed.
Още от този рафт
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
Това, което изпращате, и това, в което четете цените.
Изпратено от Вашия портфейл при поръчката
Само за визуализация — каталогът е в долари
Никоя валута не съответства.
Изберете езика, на който сайтът да Ви говори.
Нови сте тук?
Вече имате профил?
Няма автоматично нулиране: този магазин не изпраща имейли, така че няма еднократна връзка, която да поискате. Оставете адреса в профила си и той ще бъде обработен ръчно.
Заявката е приета
Нищо няма да пристигне във Вашата пощенска кутия — този магазин изобщо не изпраща имейли. Заявките се обработват ръчно.
Спомнихте си я?