Micron Technology, Inc. 2GB DDR3 1600 ECC NON-REG 1RX8 1.35V desktop RAM
- 2GB
- DDR3 1600 (PC3 1280…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replace Power
420W ATX power supply with SATA and dual ATX connectors for Compaq Presario desktops
The Replace Power RPSU-C99-41 is a 420W ATX unit built to match the original power module in Compaq Presario SR2013WM, SR2014HM, SR2015LA, SR2017CL and SR2017LA desktops. It delivers the exact wattage and form factor required by those systems. Builders working on other platforms or needing higher output should look elsewhere.
The grey chassis holds a single fan and supplies a fixed harness: one 15-inch SATA connector, one 14-inch ATX connector compatible with both 20-pin and 24-pin motherboards, one 14-inch 12V ATX connector, two 15-inch large power connectors, two 6-inch large power connectors and one 6-inch small power connector. Cable lengths are set, so routing space inside the case must accommodate the listed reaches.
Rated at 420W, the supply uses one fan to move air through the grey enclosure under normal load. Acoustic output and thermal behaviour follow the single-fan design at this wattage level. No modular cabling or alternative cooling modes are provided.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-41 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
It supplies one 15-inch SATA connector, one 14-inch ATX connector supporting both 20-pin and 24-pin layouts, one 14-inch 12V ATX connector, two 15-inch large power connectors, two 6-inch large power connectors and one 6-inch small power connector.
The unit follows the standard ATX form factor and is listed as a direct replacement for the SR2013WM, SR2014HM, SR2015LA, SR2017CL and SR2017LA models, so it mounts in the same bay with the same screw pattern.
Fit the unit into the case and secure the screws, then plug the 14-inch ATX connector into the motherboard (20-pin or 24-pin), attach the 14-inch 12V ATX cable, connect the SATA lead to drives, and finally add the large and small peripheral connectors as needed.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?