Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Rectangular silver ATX power supply unit with SATA connectors visible

godream

godream MHG2-6300P 300W ATX power supply for Emacs S11 S12 S22 SSI5000 SATA

SKU CH-1SVK-H9C7C

A 300W ATX power supply with SATA interface for Emacs S11, S12, S22 and SSI5000 systems

  • TypeATX
  • 300 W output powers Emacs S11, S12, S22 and SSI5000 systems
  • SATA interface connects drives directly without adapters
  • ATX form factor fits standard chassis mounting points
  • Unit tested working and supplied in new condition

Compatible replacement PSU for Emacs systems

This 300 W ATX power supply is built to replace the original unit in Emacs S11, S12, S22 and SSI5000 models. It delivers the same form factor and connector layout, including SATA power leads for drives. The unit is supplied new and has been tested for correct operation before shipping.

Thermals, noise and power draw in normal use

As a standard switching supply rated at 300 W, it draws only the power required by the installed components. The internal fan spins at a speed matched to load and temperature, keeping acoustics low during typical office workloads. No additional cooling or case modifications are needed for the supported Emacs chassis.

Přednosti

  • 300 W output powers Emacs S11, S12, S22 and SSI5000 systems
  • SATA interface connects drives directly without adapters
  • ATX form factor fits standard chassis mounting points
  • Unit tested working and supplied in new condition

Specifikace

TypeATX

Otázky k tomuto produktu

How do I install the MHG2-6300P power supply in an Emacs S11, S12, S22 or SSI5000 system, and what step is often missed?

Mount the ATX unit in the chassis, connect the 24-pin main power and 4-pin CPU cables, then attach the SATA power leads to each drive; the step often missed is securing the SATA connectors firmly so they do not work loose during operation.

What maintenance or replacement will the MHG2-6300P need over its service life?

Periodically clean dust from the intake and exhaust vents to maintain airflow; the internal fan is the only moving part and should be replaced if it becomes noisy or stops spinning, otherwise the 300W switching supply itself requires no scheduled component changes.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.