Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Pair of 24 inch steel sliding rails with ball bearing runners

iStarUSA Inc.

iStarUSA Inc. TC-Rail-24 24" Sliding Rail Kit case accessory

SKU CH-XRFY-8GNX2 MPN TC-Rail-24

Ball-bearing SECC steel rails extend 24 inches and support rackmount chassis up to 85 lbs

  • 24-inch length fits standard rackmount chassis
  • ball-bearing slides provide smooth server access
  • SECC steel construction supports up to 85 lbs
  • easy installation reduces rack maintenance time
  • sliding design simplifies hardware servicing

24-inch sliding rail kit for rackmount chassis

The iStarUSA TC-Rail-24 provides ball-bearing sliding rails constructed from SECC steel for standard rackmount enclosures. It allows a server or chassis to extend fully from the rack for maintenance access. The kit supports a maximum equipment weight of 85 lbs. It is intended for administrators who need reliable slide-out access to installed hardware.

Sustained load capacity and durability

The SECC steel construction and ball-bearing mechanism are rated to hold up to 85 lbs continuously while the chassis is extended. This capacity remains stable during repeated extension and retraction cycles typical in server management. The rails maintain alignment under the full rated load without permanent deformation. They are built for long-term deployment in environments where equipment is accessed regularly.

Straightforward rack installation

The kit mounts to standard rack posts using the included hardware for a typical sliding rail setup. Installation requires aligning the inner and outer rail members before securing them to the chassis and rack. A common issue occurs if the inner rails are not properly attached to the chassis sides, causing misalignment during extension. Ensuring all screws are tightened evenly prevents binding or uneven travel.

Přednosti

  • 24-inch length fits standard rackmount chassis
  • ball-bearing slides provide smooth server access
  • SECC steel construction supports up to 85 lbs
  • easy installation reduces rack maintenance time
  • sliding design simplifies hardware servicing

Specifikace

Pro tento produkt zatím nejsou zveřejněny žádné specifikace.

Otázky k tomuto produktu

How much heat or noise does the 24-inch sliding rail kit add when the server runs all day?

The steel rails themselves generate no heat or noise; only the mounted server contributes to thermal and acoustic load.

What rack hardware must I already have for the TC-Rail-24 to mount?

A standard four-post rack with front and rear mounting flanges is required; the kit bolts directly to those posts.

Will the 85 lb capacity rails work with an older, heavier chassis I want to keep?

Yes, provided the chassis weight stays at or below 85 lbs and its side mounting holes align with the rail brackets.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.