myVolts
myVolts ATX-500W 500W 115/230V power supply with red silent fan
A 500W ATX power supply with a thermally controlled 12cm red silent fan, manual 115V/230V switching and 20+4 pin motherboard connector
- TypeAT
- Quick, easy installation with clearly marked connectors
- Low energy consumption and low noise for basic desktop systems
- Automatic fan speed control via internal thermal sensor
- High safety factor from strict quality control and assurance
- Long service life of 100000 hours using high-quality materials
500 W ATX power supply for basic desktops
This 500 W ATX power supply is designed for basic desktop systems with low energy consumption and low noise. Manual 115 V/230 V switching allows use in different mains regions. Efficiency exceeds 80 %. The red silent fan runs under thermal sensor control for quiet operation.
Clearly marked connectors and robust build
The unit uses high-quality materials and strict quality control for a long service life of 100000 hours. Motherboard power is provided by a 20+4 pin connector alongside dual 4 pin CPU 12 V plugs. Four SATA connectors and a 6 pin to 6+2 pin graphics adapter cover drives and a mid-range card. Two fan headers are also included.
Check manual voltage switch and hold-up time
Verify the input voltage selector matches your local mains before powering on. Hold-up time is rated above 10 ms, which may be short for areas with unstable power. The physical size is approximately 140 x 150 x 12 mm, so confirm it fits your chassis. No active PFC is present.
Přednosti
- Quick, easy installation with clearly marked connectors
- Low energy consumption and low noise for basic desktop systems
- Automatic fan speed control via internal thermal sensor
- High safety factor from strict quality control and assurance
- Long service life of 100000 hours using high-quality materials
Specifikace
| Type | AT |
|---|
Otázky k tomuto produktu
Does the manual 115/230V switch limit the unit to 80% efficiency?
The supply is rated above 80% efficiency; the manual voltage selector does not change that figure.
Will the 140 x 150 mm chassis fit a standard ATX case?
At 140 mm wide by 150 mm deep it matches the common ATX footprint, but verify your case clearance before mounting.
How do I connect the 20+4 pin motherboard plug without bending pins?
Align the keyed connector, press straight in until the latch clicks, and do not force the extra four pins if your board uses only 20.
Také v této kategorii
Zákazníci také porovnávali
Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.
Silverstone RM22-312 2U 12-bay 2.5" / 3.5" server chassis
- Rackmount
iStarUSA Inc. D400-6SE-B6SA-SL 4U Rackmount Server Chassis 6 Hot-Swap Bays
- Rackmount
- 4U



