Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Two green DDR5 RDIMM modules with black chips and gold contacts, no heat spreaders

NEMIX RAM

NEMIX RAM 64GB (2x32GB) DDR5 5600 CL46 2Rx8 ECC RDIMM Supermicro H14SSL-N memory upgrade

SKU CH-D79A-2W69E

A 64GB kit of two 32GB DDR5 5600 CL46 2Rx8 registered ECC RDIMMs at 1.1V for the Supermicro H14SSL-N motherboard

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 64GB 2X32GB

Zobrazit dalších 24 konfigurací
  • Exact 64 GB kit matches Supermicro H14SSL-N memory controller requirements
  • Registered ECC RDIMM design prevents single-bit errors and supports full population
  • DDR5 5600 CL46 at 1.1 V delivers rated speed without manual tuning
  • 2Rx8 288-pin modules fit the board's approved DIMM slots precisely
  • Lifetime replacement warranty with US-based technical support included

Exact-match DDR5-5600 ECC RDIMM kit

This 64GB kit contains two 32GB DDR5 5600 registered ECC modules built to the precise rank, voltage and timing the Supermicro H14SSL-N memory controller expects. It is intended for administrators upgrading that specific server platform to its full supported capacity. Buyers needing non-ECC UDIMMs or a different form factor should look elsewhere.

Registered architecture

The registered design buffers address and command signals so every slot can run fully populated at the rated 5600 speed while ECC corrects single-bit errors on the fly. Modules operate at 1.1V without a heat spreader and use the 288-pin RDIMM connector this board requires, not a UDIMM or SODIMM socket. Systems that only accept unbuffered memory cannot use this kit.

Verify manual before ordering

Server memory support varies by model and BIOS revision. Consult the Supermicro H14SSL-N manual for approved DIMM population order, maximum capacity per channel and any required firmware updates before purchase. This kit is validated for that motherboard only; other Supermicro boards or different vendors may have incompatible population rules.

Přednosti

  • Exact 64 GB kit matches Supermicro H14SSL-N memory controller requirements
  • Registered ECC RDIMM design prevents single-bit errors and supports full population
  • DDR5 5600 CL46 at 1.1 V delivers rated speed without manual tuning
  • 2Rx8 288-pin modules fit the board's approved DIMM slots precisely
  • Lifetime replacement warranty with US-based technical support included

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-328K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Does the DDR5 5600 interface cap at PC5-44800 bandwidth?

Yes, the kit runs at DDR5 5600 which equals PC5-44800, so that is the maximum data rate the modules will deliver on this platform.

Will the 288-pin RDIMM form factor fit the Supermicro H14SSL-N DIMM slots?

The board requires 288-pin registered DIMMs; these modules match that exact pin count and registered design, so they seat correctly in every supported slot.

How are the two 32 GB modules installed, and which step is often missed?

Install the pair in the motherboard's prescribed population order — usually the first slot of each channel — and fully seat both modules until the retention clips lock; skipping the manual's slot sequence is the common error.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.