Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Green printed circuit board with black memory chips and gold edge connectors

NEMIX RAM

NEMIX RAM 64GB DDR5 4800MHz CL40 2Rx4 1.1V ECC Registered RDIMM 288-Pin Supermicro H13SST-GC memory upgrade

SKU CH-MC9V-2ETDM

A 64GB DDR5 RDIMM running at 4800MHz with CL40 latency and 1.1V ECC registered operation for the Supermicro H13SST-GC motherboard

  • Capacity64GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 64GB

Zobrazit dalších 24 konfigurací
  • Exact DDR5-4800 spec match ensures full-speed recognition
  • Registered ECC architecture prevents silent data corruption
  • 2Rx4 1.1V 288-pin RDIMM fits Supermicro H13SST-GC
  • CL40 latency with PC5-38400 bandwidth for server workloads
  • Lifetime replacement warranty with US-based technical support

Exact-match DDR5-4800 RDIMM for Supermicro H13SST-GC

This 64 GB registered ECC module runs at DDR5-4800 (PC5-38400) with CL40 latency at 1.10 V. The 2Rx4 organisation and 288-pin RDIMM form factor match the memory controller requirements of the Supermicro H13SST-GC motherboard so the system recognises the full capacity at rated speed. It is built for servers that demand registered DIMMs with on-die error correction.

Upgrade from slower or smaller DDR5 RDIMMs

Replacing lower-capacity or lower-speed registered DDR5 DIMMs with this 64 GB CL40 kit lets you fill every supported slot at the board's native 4800 MT/s rate. The jump is worthwhile when the workload needs maximum registered DIMM density per channel and the platform's qualified-vendor list includes this exact rank, voltage and timing combination. Systems limited to UDIMMs or SODIMMs cannot use this module.

Limited to platforms qualified for 2Rx4 registered

The DDR5 interface here operates only at the single JEDEC speed grade of 4800 MT/s with 1.10 V signalling. Boards that require different ranks, voltages or unbuffered DIMMs will not post with this module installed. Population rules, maximum capacity per channel and supported DIMM counts are defined by the motherboard firmware and must be verified in the system manual before installation.

Přednosti

  • Exact DDR5-4800 spec match ensures full-speed recognition
  • Registered ECC architecture prevents silent data corruption
  • 2Rx4 1.1V 288-pin RDIMM fits Supermicro H13SST-GC
  • CL40 latency with PC5-38400 bandwidth for server workloads
  • Lifetime replacement warranty with US-based technical support

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-924K1
Capacity64GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Will this 288-pin DDR5 RDIMM fit the Supermicro H13SST-GC motherboard slots?

Yes, the module uses the 288-pin RDIMM form factor required by the H13SST-GC and matches the board's DDR5 memory-controller specification.

What is the correct installation order for this 2Rx4 registered ECC module?

Install modules in the population sequence shown in the Supermicro H13SST-GC manual; registered DIMMs must fill slots in the prescribed order so the memory controller initialises every rank at 4800 MHz.

Does the lack of a heat spreader mean this 1.1 V module needs extra airflow?

The module runs at the standard 1.1 V DDR5 voltage; adequate chassis airflow per the server manufacturer's guidelines is sufficient — no additional cooling is required.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.