Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Eight green DDR5 RDIMM modules without heat spreaders in a tray

NEMIX RAM

NEMIX RAM DDR5 4800 768GB 8x96GB ECC RDIMM CL40 1.1V 2Rx4 Supermicro H13SST-GC memory upgrade

SKU CH-FD57-16FNB

768GB DDR5 4800 ECC registered RDIMM kit of eight 96GB modules at CL40 and 1.1V, validated for Supermicro H13SST-GC

  • Capacity768GB (8 x 96GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 768GB 8X96GB

Zobrazit dalších 24 konfigurací
  • 768 GB total capacity across eight 96 GB modules for dense server workloads
  • DDR5 4800 speed with CL40 latency delivers rated throughput for the H13SST-GC
  • Registered ECC RDIMM design corrects single-bit errors and stabilises fully populated slots
  • 1 V operating voltage matches the board's memory-controller specification exactly
  • 288-pin 2Rx4 form factor ensures mechanical and electrical fit in every supported slot

768GB DDR5 RDIMM kit for Supermicro H13SST-GC

This 768GB kit contains eight 96GB DDR5-4800 registered ECC RDIMMs built for the Supermicro H13SST-GC motherboard. Each module runs at 1.1V with CL40 latency and a 2Rx4 organisation. The registered design lets every slot run fully populated at rated speed.

Check manual for population rules

Server memory support varies by model and BIOS revision. Consult the system or motherboard manual for approved DIMM population order, maximum supported capacity per slot, and installation steps before ordering. The kit uses 288-pin registered RDIMMs, not UDIMMs or SODIMMs.

Replaces smaller RDIMM sets when full 768GB is

The upgrade is worth it when workloads demand the full eight-module capacity at DDR5-4800 with ECC protection. Registered buffering offloads the memory controller so all slots operate at rated speed. Buyers who need fewer modules or a different capacity should look elsewhere.

Přednosti

  • 768 GB total capacity across eight 96 GB modules for dense server workloads
  • DDR5 4800 speed with CL40 latency delivers rated throughput for the H13SST-GC
  • Registered ECC RDIMM design corrects single-bit errors and stabilises fully populated slots
  • 1 V operating voltage matches the board's memory-controller specification exactly
  • 288-pin 2Rx4 form factor ensures mechanical and electrical fit in every supported slot

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-9624K8
Capacity768GB (8 x 96GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content768GB 8X96GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

What does the 768GB 8x96GB kit include and is anything else required for installation?

The kit contains eight 96GB DDR5 4800 RDIMM modules, totalling 768GB. No additional parts are needed; install them directly into the Supermicro H13SST-GC motherboard following its population guide.

Should I choose this CL40 2Rx4 kit or a different speed or rank for the H13SST-GC?

This CL40 2Rx4 DDR5-4800 kit matches the exact rank, voltage and timing the H13SST-GC memory controller expects, ensuring full-capacity recognition at rated speed.

What does the DDR5-4800 PC5-38400 rating mean once the modules are running in the server?

The modules will operate at 4800 MT/s with CL40 latency at 1.1V, delivering the bandwidth and error-correcting stability the registered ECC design provides for production workloads.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.