Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Twelve green DDR5 RDIMM modules in anti-static tray

NEMIX RAM

NEMIX RAM DDR5 4800 ECC Registered RDIMM 384GB (12 x 32GB) memory upgrade for GIGABYTE MZ33-CP1

SKU CH-C077-7FJV7

A 384GB kit of twelve 32GB DDR5-4800 ECC registered RDIMMs validated for the GIGABYTE MZ33-CP1 server platform

  • Capacity384GB (12 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 384GB 12X32GB

Zobrazit dalších 18 konfigurací
  • 384 GB total capacity from twelve 32 GB modules enables dense server workloads
  • DDR5-4800 PC5-38400 speed matches the board's rated memory frequency
  • Registered ECC with 2Rx8 organisation corrects single-bit errors and offloads the memory controller
  • 1 V operation and CL40 timing meet the exact voltage and latency the platform expects
  • 288-pin RDIMM form factor fits the GIGABYTE MZ33-CP1 motherboard slots

Exact-match server upgrade

This 384GB kit delivers twelve 32GB DDR5 RDIMMs clocked at 4800MHz for the GIGABYTE MZ33-CP1 motherboard. Registered ECC modules with 2Rx8 organisation and CL40 timing match the board's memory controller requirements so the full capacity is recognised at rated speed. It targets administrators who need maximum registered memory in every slot of that specific platform.

Sustained enterprise stability

Registered architecture buffers the command bus, allowing all twelve slots to remain fully populated at 4800MHz without signal degradation over long workloads. ECC corrects single-bit errors on the fly, preventing silent data corruption and unplanned reboots during continuous operation. The 1.1V operating voltage keeps power draw consistent across the kit under load.

Twelve-module population discipline

The 288-pin RDIMM form factor fits only the registered DIMM sockets defined by the MZ33-CP1 layout; UDIMM or SODIMM modules will not seat. Builders must follow the motherboard manual for approved population order and per-slot capacity limits before installation. No heat spreaders are present, so chassis airflow must cover the bare DRAM packages directly.

Přednosti

  • 384 GB total capacity from twelve 32 GB modules enables dense server workloads
  • DDR5-4800 PC5-38400 speed matches the board's rated memory frequency
  • Registered ECC with 2Rx8 organisation corrects single-bit errors and offloads the memory controller
  • 1 V operation and CL40 timing meet the exact voltage and latency the platform expects
  • 288-pin RDIMM form factor fits the GIGABYTE MZ33-CP1 motherboard slots

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-328K12
Capacity384GB (12 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content384GB 12X32GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

How much power does the 1.1V DDR5-4800 RDIMM kit draw when the server runs continuously?

Each module operates at 1.10V; total system power depends on the motherboard's memory controller and population rules, so consult the GIGABYTE MZ33-CP1 manual for exact figures.

What motherboard feature must my GIGABYTE MZ33-CP1 have to accept this 288-pin registered ECC kit?

The board must provide DDR5 RDIMM slots that support registered ECC modules at 4800 MT/s with 2Rx8 organisation and 1.10V operation.

Will the CL40 2Rx8 modules work in my MZ33-CP1 alongside any existing DDR5 RDIMMs I keep?

Mixing ranks, latencies or voltages can prevent the server from booting at full 384GB capacity; follow the motherboard's approved population order and use identical modules for all populated slots.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.