Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Two green circuit boards with black chips and gold edge connectors lying side by side

NEMIX RAM

NEMIX RAM DDR5 5600 CL46 96GB (2x48GB) UDIMM for Supermicro X13SAE memory upgrade

SKU CH-PM6G-RDJP9

A 96 GB DDR5 kit with two 48 GB UDIMMs rated at 5600 MT/s, CL46 and 1.1 V, validated for the Supermicro X13SAE motherboard

  • Capacity96GB (2 x 48GB)
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo

Size 96GB 2X48GB

  • 96 GB capacity from two 48 GB modules doubles your desktop memory headroom
  • DDR5-5600 speed with CL46 latency delivers rated bandwidth for Supermicro X13SAE
  • 10 V operation at 2Rx8 rank matches the motherboard memory controller expectations
  • Major OEM Samsung Micron Hynix chips tested for stability at rated speed and timing
  • 288-pin unbuffered UDIMM form factor fits the exact slot type your board requires

96GB DDR5 kit for Supermicro X13SAE

This 96GB kit contains two 48GB DDR5 UDIMM modules rated at 5600MHz with CL46 latency and 1.1V operation. It is built as an exact-match upgrade for the Supermicro X13SAE motherboard using major OEM chips from Samsung, Micron or Hynix. The non-ECC unbuffered design suits desktop and workstation platforms that require standard UDIMM population.

Installation fits standard 288-pin DDR5 slots

Each module uses the 288-pin UDIMM form factor and installs like any desktop DIMM; no heat spreader is fitted so clearance is minimal. The kit is validated for the X13SAE memory-population rules so the board recognises the full 96GB at rated speed. Builders should still consult the motherboard manual for approved slot order and maximum supported capacity before fitting.

DDR5-5600 bandwidth and density limits

The PC5-44800 rating delivers 5600MT/s transfer rates at CL46, which is the baseline JEDEC speed for this generation. Two-rank 2Rx8 organisation allows the 48GB density per module but does not increase per-pin bandwidth beyond the standard. Systems that cannot train at 5600MT/s will fall back to lower JEDEC speeds, and total capacity is capped by the board's memory-controller limits.

Přednosti

  • 96 GB capacity from two 48 GB modules doubles your desktop memory headroom
  • DDR5-5600 speed with CL46 latency delivers rated bandwidth for Supermicro X13SAE
  • 10 V operation at 2Rx8 rank matches the motherboard memory controller expectations
  • Major OEM Samsung Micron Hynix chips tested for stability at rated speed and timing
  • 288-pin unbuffered UDIMM form factor fits the exact slot type your board requires

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-4828K2
Capacity96GB (2 x 48GB)
Type288-Pin DDR5 UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content96GB 2X48GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

How can I verify the kit runs at DDR5 5600 CL46 after installation?

Enter the BIOS and confirm the memory frequency reads 5600 MHz with CAS latency 46; the modules operate at 1.1 V so the voltage should also show 1.10 V.

What is included in the package and do I need any extra parts?

The box contains two 48 GB DDR5 5600 UDIMMs for a total of 96 GB; no heat spreader or additional cables are supplied and nothing else is required for installation.

Why choose the 96 GB 2x48 GB version instead of a smaller kit?

This 96 GB kit (2 x 48 GB) matches the Supermicro X13SAE's supported capacity and population rules, delivering the full 96 GB in two 288-pin UDIMM slots.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.