Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Two green DDR5 RDIMM modules with black chips no heat spreader

NEMIX RAM

NEMIX RAM DDR5 6400 64GB 2x32GB ECC RDIMM Supermicro X14SDV-36C-SP3F memory upgrade

SKU CH-7NSR-V883A

A 64 GB DDR5-6400 registered ECC kit (2 × 32 GB, 1.1 V, CL52, 2Rx4, 288-pin) validated for the Supermicro X14SDV-36C-SP3F motherboard

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes

Size 64GB 2X32GB

  • 64 GB capacity across two 32 GB modules expands server memory headroom for virtualization workloads
  • DDR5 6400 speed with CL52 latency delivers rated throughput for Supermicro X14SDV-36C-SP3F platforms
  • Registered ECC architecture corrects single-bit errors on the fly to prevent silent data corruption
  • 10 V operation at 2Rx4 rank matches the memory controller's exact voltage and timing requirements
  • 288-pin RDIMM form factor fits the motherboard's registered DIMM slots without adapter or modification

Capacity and purpose

This 64 GB kit contains two 32 GB DDR5 6400 RDIMM modules built for the Supermicro X14SDV-36C-SP3F motherboard. The registered ECC design targets servers and workstations that require error correction and full-slot population at rated speed.

Sustained-load behaviour

Registered buffering reduces electrical load on the memory controller so all populated slots operate at DDR5 6400 without downclocking. ECC corrects single-bit errors in real time, preventing silent data corruption during continuous workloads.

Pre-installation checks

Verify the motherboard manual for approved DIMM population order, maximum supported capacity per slot, and any BIOS version requirements before installation. This kit uses 288-pin RDIMM form factor and 1.1 V operation; it is not compatible with UDIMM or SODIMM slots.

Přednosti

  • 64 GB capacity across two 32 GB modules expands server memory headroom for virtualization workloads
  • DDR5 6400 speed with CL52 latency delivers rated throughput for Supermicro X14SDV-36C-SP3F platforms
  • Registered ECC architecture corrects single-bit errors on the fly to prevent silent data corruption
  • 10 V operation at 2Rx4 rank matches the memory controller's exact voltage and timing requirements
  • 288-pin RDIMM form factor fits the motherboard's registered DIMM slots without adapter or modification

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-324K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR5 6400MHz PC5-51200 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

How much power does this 1.1 V DDR5 6400 kit draw when the Supermicro X14SDV-36C-SP3F runs fully populated all day?

Each module operates at 1.10 V, the standard DDR5 voltage, so total draw scales with the 64 GB capacity and 2Rx4 registered design; the board's memory controller manages power per slot.

What must the Supermicro X14SDV-36C-SP3F already have to accept this 288-pin RDIMM kit?

The motherboard needs DDR5 RDIMM slots wired for registered ECC memory and a CPU memory controller that supports DDR5 6400 at 1.1 V with 2Rx4 population rules.

Can I keep existing DDR5 RDIMMs in the other channels while adding this 2Rx4 CL52 kit?

Yes, provided the other modules are also DDR5 registered ECC at 1.1 V; the board will train all channels to the lowest common speed and latency.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.