Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Four black DDR3 UDIMM modules, no heat spreaders, 240-pin form factor

OWC

OWC 32GB (4x8GB) DDR3 1600 ECC Unbuffered Desktop RAM

SKU CH-PTZN-D9DQT

A 32GB kit of four 8GB DDR3 1600 ECC unbuffered DIMMs for desktops, workstations or servers

  • Capacity32GB (4 x 8GB)
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Voltage1.5V
  • ECCYes
  • Buffered/RegisteredUnbuffered

Capacity 32GB (4 x 8GB)

  • ECC protection safeguards data integrity in critical workloads
  • 32GB capacity across four 8GB modules enables heavy multitasking
  • 1600MHz DDR3 speed with CL11 latency delivers responsive performance
  • 5V JEDEC-standard voltage ensures broad desktop and server compatibility
  • 240-pin unbuffered DIMM form factor fits standard workstation and NAS slots

32GB DDR3 ECC kit for workstations

This 32GB kit contains four 8GB DDR3 1600 modules built to JEDEC PC3-12800 CL11 specifications. ECC unbuffered operation adds single-bit error correction for data integrity in workstations, servers and NAS systems. The modules run at 1.5V and use the standard 240-pin DIMM form factor.

JEDEC and ROHS compliance simplify upgrades

Full JEDEC compliance means the kit meets the published DDR3 electrical and timing standards without proprietary extensions. ROHS compliance removes restricted substances for broader regulatory acceptance. Together they make the upgrade warranty-safe on systems that require standard-spec memory.

DDR3 1600 interface limits maximum bandwidth

The PC3-12800 rating caps theoretical peak transfer rate at 12800 MB/s per channel. CL11 latency sets the minimum command-to-data delay at eleven cycles. Systems that only support lower DDR3 speeds or non-ECC memory will not gain the rated bandwidth or error-correction benefit.

Přednosti

  • ECC protection safeguards data integrity in critical workloads
  • 32GB capacity across four 8GB modules enables heavy multitasking
  • 1600MHz DDR3 speed with CL11 latency delivers responsive performance
  • 5V JEDEC-standard voltage ensures broad desktop and server compatibility
  • 240-pin unbuffered DIMM form factor fits standard workstation and NAS slots

Specifikace

BrandOWC
Part Number1E6D32R8032S
Capacity32GB (4 x 8GB)
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Voltage1.5V
ECCYes
Buffered/RegisteredUnbuffered
Multi-channel KitDual Channel Kit
ColorBlack
Heat SpreaderNo
Recommend UseWorkstations, Servers, and NAS Systems
LED ColorNone

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Will these 240-pin DDR3 modules fit my desktop motherboard?

The kit uses the standard 240-pin UDIMM form factor for DDR3 desktops, workstations and servers. Check your board manual to confirm it accepts unbuffered ECC DIMMs at 1.5 V.

Can I mix this ECC kit with non-ECC memory already installed?

Mixing ECC and non-ECC DIMMs is not recommended; most platforms will disable ECC or refuse to boot. Replace all modules with this matched 4×8 GB kit for reliable operation.

Does the CL11 latency at 1600 MHz suit a typical workstation workload?

CL11 at 1600 MHz is the standard JEDEC timing for DDR3-1600 and provides stable performance for workstation, server and NAS tasks.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.