NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.
KHACHIMO
ATX power supply with 80 PLUS Gold efficiency, 290 W output, 8-pin connector, Zero RPM fan mode, Modern Standby support and resonant LLC topology with DC-to-DC conversion
The KHACHIMO 290W ATX unit is built as a direct replacement for Dell OptiPlex 3020, 7020, 9020, 3670 and 1700 small-form-factor desktops. It fits the proprietary chassis and connector layout used across those five model families. Buyers who need a standard ATX PSU for a custom build or a non-Dell chassis cannot use this unit.
The only output that matters for compatibility is the single 8-pin connector wired to the Dell-specific pinout found on the listed OptiPlex boards. If your motherboard uses a 24-pin ATX header or requires additional PCIe power cables, this supply will not connect.
At 80 PLUS Gold certification the unit maintains high efficiency across the load range, reducing waste heat inside the compact case. The Zero RPM fan mode stops the fan completely at low and medium loads, while the resonant LLC topology with DC-to-DC conversion delivers clean power and suppresses coil whine during sustained operation.
| Type | ATX |
|---|
The 290 W rating is the maximum continuous power the unit can deliver across all rails, so it suits small-form-factor PCs with modest CPUs and no discrete graphics card.
It follows the ATX form factor, which fixes the physical dimensions and the 24-pin main connector layout, limiting it to cases and motherboards built for standard ATX power supplies.
The supply uses the standard ATX chassis footprint with four rear mounting holes, so it fits any case designed for an ATX power supply without extra brackets.
Også på denne hylde
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
Det du betaler med, og det du ser priserne i.
Sendes fra din tegnebog i kassen
Kun til visning — kataloget er prissat i USD
Ingen valuta matcher det.
Vælg det sprog, siden taler til dig på.
Ny her?
Har du allerede en?
Der findes ingen automatisk nulstilling: denne butik sender ingen e-mails, så der er intet engangslink at bede om. Efterlad adressen på kontoen, så bliver den behandlet manuelt.
Anmodning registreret
Der er intet på vej til din indbakke — denne butik sender slet ingen e-mails. Nogen behandler dem manuelt.
Kom du i tanke om den?