NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.
Replace Power
A 420W ATX power supply with an 80mm fan, switchable 110V and 220V input, and connectors including 20+4 ATX, ATX12V, SATA, peripheral and floppy
This 420W ATX power supply replaces faulty or ageing units in HP desktops and other compatible systems. It delivers the rated wattage through a standard ATX form factor with a single 80mm fan for cooling. The grey chassis fits directly into the same mounting points as the original equipment.
The unit serves as a direct swap for HP part numbers 376649-001 405479-001 405872-001 410507-002 and matches the original 420W rating. The jump is worth it when the existing supply has failed, shows voltage instability or cannot sustain load under normal operation. Input voltage is switchable between 110V and 220V for regional compatibility.
The supply provides one SATA connector, a 20+4 pin ATX connector, a 12V ATX connector, two large peripheral connectors, two short peripheral connectors and one floppy connector. Cable lengths of 14-inch and 15-inch reach typical drive bays and motherboard headers. Builders needing additional SATA devices or multiple 12V CPU connectors should verify requirements before purchase.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-8 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
The unit uses a single 80 mm fan; allow enough depth behind the rear panel for the fan housing and cable bend radius so airflow is not restricted.
The supplied 14-inch ATX lead supports both 20-pin and 24-pin layouts; plug the full 24-pin block into the board and leave the extra four pins unattached if the socket is 20-pin.
Clean the 80 mm fan intake with compressed air every six to twelve months; replace the fan if bearing noise appears or airflow drops noticeably.
Også på denne hylde
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
Det du betaler med, og det du ser priserne i.
Sendes fra din tegnebog i kassen
Kun til visning — kataloget er prissat i USD
Ingen valuta matcher det.
Vælg det sprog, siden taler til dig på.
Ny her?
Har du allerede en?
Der findes ingen automatisk nulstilling: denne butik sender ingen e-mails, så der er intet engangslink at bede om. Efterlad adressen på kontoen, så bliver den behandlet manuelt.
Anmodning registreret
Der er intet på vej til din indbakke — denne butik sender slet ingen e-mails. Nogen behandler dem manuelt.
Kom du i tanke om den?