OWC 32GB (4x8GB) DDR3 1866 CL13 ECC Registered RDIMM server RAM
- 32GB (4 x 8GB)
- 240-Pin DDR3 ECC RD…
Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.
OWC
32 GB DDR3L 1600 ECC registered RDIMM kit (4 × 8 GB) for Cisco UCS C200 M2 and C210 M2 servers
Capacity 32GB (4 x 8GB)
This OWC kit supplies 32GB of DDR3L memory across four 8GB registered DIMMs. It is built for Cisco UCS C200 M2 and C210 M2 servers that require ECC registered modules. The kit will not work in standard desktop computers or alongside unbuffered or load-reduced memory.
Each module operates at 1.35V, the standard DDR3L voltage, which reduces power draw compared with 1.5V DDR3. No heat spreaders are fitted, so airflow through the server chassis handles cooling. Registered buffering adds minimal electrical load on the memory controller.
ECC registered operation corrects single-bit errors during continuous workloads, helping maintain data integrity in virtualisation or database tasks. CL11 latency at 1600MHz provides consistent timing for long-running server applications. The four-module population fills four slots for balanced channel utilisation.
| Brand | OWC |
|---|---|
| Part Number | 1R6T32R4032S |
| Capacity | 32GB (4 x 8GB) |
| Type | 240-Pin DDR3L ECC RDIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | Cisco UCS C200 M2 Cisco UCS C210 M2 |
Selle mudeli teised versioonid
Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.
Power down the server, open the chassis, align each 240-pin module with the DDR3L slot key, press firmly until both retention clips lock, then verify in BIOS that all 32GB (4×8GB) are detected at 1600 MHz CL11; the step often missed is confirming the registered ECC mode is enabled.
No routine maintenance is required; if a module fails, replace the faulty 8GB 2Rx4 RDIMM with an identical DDR3L 1600 CL11 1.35V registered ECC part to keep matched ranks across the four slots.
The memory controller’s maximum supported frequency of 1600 MHz and the registered buffer’s timing at CL11 set the throughput ceiling; thermal throttling is unlikely at the standard 1.35V operating voltage.
Veel samast osakonnast
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
See, millega maksate, ja see, milles vaatate hindu.
Saadetud teie rahakotist kassas
Ainult kuvamiseks — kataloogi hinnad on dollarites
Ükski vääring ei vasta sellele.
Valige keel, milles sait teiega räägib.
Ükski keel ei vasta.
Esimest korda siin?
Teil on juba konto?
Automaatset lähtestamist ei ole: see pood ei saada ühtegi e-kirja, seega pole ka ühekordset linki, mida küsida. Jätke aadress kontole alles, seda käsitletakse käsitsi.
Päring registreeritud
Teie postkasti ei jõua midagi — see pood ei saada e-kirju üldse. Keegi tegeleb sellega käsitsi.
Tuli meelde?