OWC 32GB (4x8GB) DDR3 1866 CL13 ECC Registered RDIMM server RAM
- 32GB (4 x 8GB)
- 240-Pin DDR3 ECC RD…
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
OWC
32 GB DDR3L 1600 ECC registered RDIMM kit (4 × 8 GB) for Cisco UCS C200 M2 and C210 M2 servers
Capacity 32GB (4 x 8GB)
This OWC kit supplies 32GB of DDR3L memory across four 8GB registered DIMMs. It is built for Cisco UCS C200 M2 and C210 M2 servers that require ECC registered modules. The kit will not work in standard desktop computers or alongside unbuffered or load-reduced memory.
Each module operates at 1.35V, the standard DDR3L voltage, which reduces power draw compared with 1.5V DDR3. No heat spreaders are fitted, so airflow through the server chassis handles cooling. Registered buffering adds minimal electrical load on the memory controller.
ECC registered operation corrects single-bit errors during continuous workloads, helping maintain data integrity in virtualisation or database tasks. CL11 latency at 1600MHz provides consistent timing for long-running server applications. The four-module population fills four slots for balanced channel utilisation.
| Brand | OWC |
|---|---|
| Part Number | 1R6T32R4032S |
| Capacity | 32GB (4 x 8GB) |
| Type | 240-Pin DDR3L ECC RDIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | Cisco UCS C200 M2 Cisco UCS C210 M2 |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
Power down the server, open the chassis, align each 240-pin module with the DDR3L slot key, press firmly until both retention clips lock, then verify in BIOS that all 32GB (4×8GB) are detected at 1600 MHz CL11; the step often missed is confirming the registered ECC mode is enabled.
No routine maintenance is required; if a module fails, replace the faulty 8GB 2Rx4 RDIMM with an identical DDR3L 1600 CL11 1.35V registered ECC part to keep matched ranks across the four slots.
The memory controller’s maximum supported frequency of 1600 MHz and the registered buffer’s timing at CL11 set the throughput ceiling; thermal throttling is unlikely at the standard 1.35V operating voltage.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?