OWC 32GB (4x8GB) DDR3 1866 CL13 ECC Registered RDIMM server RAM
- 32GB (4 x 8GB)
- 240-Pin DDR3 ECC RD…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
32 GB DDR3L 1600 ECC registered RDIMM kit (4 × 8 GB) for Cisco UCS C200 M2 and C210 M2 servers
Capacity 32GB (4 x 8GB)
This OWC kit supplies 32GB of DDR3L memory across four 8GB registered DIMMs. It is built for Cisco UCS C200 M2 and C210 M2 servers that require ECC registered modules. The kit will not work in standard desktop computers or alongside unbuffered or load-reduced memory.
Each module operates at 1.35V, the standard DDR3L voltage, which reduces power draw compared with 1.5V DDR3. No heat spreaders are fitted, so airflow through the server chassis handles cooling. Registered buffering adds minimal electrical load on the memory controller.
ECC registered operation corrects single-bit errors during continuous workloads, helping maintain data integrity in virtualisation or database tasks. CL11 latency at 1600MHz provides consistent timing for long-running server applications. The four-module population fills four slots for balanced channel utilisation.
| Brand | OWC |
|---|---|
| Part Number | 1R6T32R4032S |
| Capacity | 32GB (4 x 8GB) |
| Type | 240-Pin DDR3L ECC RDIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | Cisco UCS C200 M2 Cisco UCS C210 M2 |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power down the server, open the chassis, align each 240-pin module with the DDR3L slot key, press firmly until both retention clips lock, then verify in BIOS that all 32GB (4×8GB) are detected at 1600 MHz CL11; the step often missed is confirming the registered ECC mode is enabled.
No routine maintenance is required; if a module fails, replace the faulty 8GB 2Rx4 RDIMM with an identical DDR3L 1600 CL11 1.35V registered ECC part to keep matched ranks across the four slots.
The memory controller’s maximum supported frequency of 1600 MHz and the registered buffer’s timing at CL11 set the throughput ceiling; thermal throttling is unlikely at the standard 1.35V operating voltage.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?