NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
A-Tech
4GB DDR4 2133 CL15 desktop module at 1.2V for G.Skill F4-2133C15D-8GVR replacement
This 4GB DDR4 2133 CL15 DIMM is built as a compatible replacement for G.Skill F4-2133C15D-8GVR kits. It runs at 2133 MHz with standard 1.20 V operation. The unbuffered non-ECC design fits typical consumer desktop boards. A-Tech tests every module before it ships.
The single 4GB stick works well for a basic capacity bump on a board with a free 288-pin slot. Users needing dual-channel bandwidth or 8GB and up should look at a matched kit instead. Systems that require registered or ECC memory cannot use this module.
The CL15 timing at 2133 MHz sets the access speed for this module. If your platform demands tighter latency or a higher data rate this part will not meet that requirement. Verify the motherboard qualification list before ordering.
| Brand | A-Tech |
|---|---|
| Series | Compatible Replacement for G.Skill |
| Model | F4-2133C15D-8GVR |
| Capacity | 4GB |
| Speed | DDR4 2133 (PC4 17000) |
| Tested Frequency | 2133 |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Features | F4-2133C15D-8GVR |
| Recommend Use | Compatible Replacement for G.Skill F4-2133C15D-8GVR |
This listing is a single 4GB DDR4 2133 CL15 DIMM. Add one module if your board has a free slot and you only need a small capacity boost; choose a matched kit of two or more modules if you want dual-channel bandwidth or a higher total capacity.
The module runs at 2133 MHz with CL15 latency at the standard 1.20 V. In a real system it will operate at the highest speed your motherboard and CPU memory controller both support, which may be 2133 MHz or a lower JEDEC frequency if the platform cannot run that fast.
Yes — the stick uses the standard 288-pin DDR4 DIMM form factor (PC4-17000) and is unbuffered non-ECC, so it fits any desktop board with DDR4 slots that accept 1.20 V UDIMMs.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?