NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
A-Tech
8GB DDR3 1333MHz desktop module runs at 1.5V with 240-pin unbuffered non-ECC design for AMD and Intel systems
This A-Tech module is an 8GB DDR3 DIMM that runs at 1333MHz with a standard 1.50V supply. It uses a 240-pin unbuffered, non-ECC design and is built as a direct replacement for Micron MT16JTF1G64AZ-1G4 and MT16JTF1G64AZ-1G4D1 parts. The single stick adds 8GB of capacity to a compatible desktop system.
This module suits owners of desktops that accept DDR3 1333MHz PC3-10600 unbuffered non-ECC memory in a 240-pin slot. Builders who need ECC error correction, registered buffering, a different DDR generation, or speeds other than 1333MHz should look at something else. Systems limited to lower maximum module densities will not support this 8GB stick.
The deciding specification is the DDR3 1333MHz PC3-10600 240-pin unbuffered non-ECC standard at 1.50V. Your motherboard and CPU memory controller must explicitly support this exact combination of generation, speed, voltage, form factor, and buffering type. Verify the system manual before purchase; an incorrect generation or voltage will prevent the module from functioning.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR3 1333 (PC3 10600) |
| Tested Frequency | 1333 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Recommend Use | AMD & Intel Compatible |
The package contains one 8GB DDR3 1333MHz PC3-10600 240-Pin DIMM module; no tools, cables or additional memory sticks are supplied.
This is a single 8GB module; if your board supports dual-channel you can add a second identical stick later, but a matched 2x4GB kit would enable dual-channel immediately.
The module is tested at 1333MHz with standard 1.50V DDR3 voltage; the final operating speed is set by the memory controller in your CPU and the motherboard BIOS.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?