Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR3 DIMM sticks with black chips

Computer Memory Solutions

Computer Memory Solutions 4GB (2x2GB) DDR3 1333MHz CL9 1.5V 240-Pin DIMM Kit for eMachines EL1352G

SKU CH-18SN-ZENXK

4GB dual-channel DDR3 kit running at 1333 MHz with CL9 timing and 1.5 V, supplied as two 240-pin unbuffered DIMMs validated for the eMachines EL1352G desktop

  • Capacity4GB (2 x 2GB)
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Timing9-9-9
  • Voltage1.5V
  • 4GB kit upgrades eMachines EL1352G desktop
  • Two 2GB modules enable dual-channel DDR3 bandwidth
  • 1333 MHz CL9 timing matches system spec
  • 5 V unbuffered non-ECC DIMMs fit standard slots
  • 240-pin DDR3 form factor installs without adapters

System-specific DDR3 kit for eMachines EL1352G

This 4 GB kit contains two 2 GB unbuffered DIMMs built to run at 1333 MHz with CL9 timing at 1.5 V. It is validated for the eMachines EL1352G desktop so buyers can install it without guessing compatibility.

Two matched modules remove single-channel bottleneck

The paired sticks let the memory controller operate in dual-channel mode, doubling the data path compared with a single module. No heat spreaders are included, keeping the profile low for tight chassis clearance.

DDR3 1333 interface caps peak bandwidth at PC3-10600

The 240-pin DDR3 standard used here tops out at 10600 MB/s theoretical throughput, so workloads that need higher sustained rates will hit this ceiling. Systems requiring ECC or registered memory cannot use this unbuffered non-ECC kit.

Kohokohdat

  • 4GB kit upgrades eMachines EL1352G desktop
  • Two 2GB modules enable dual-channel DDR3 bandwidth
  • 1333 MHz CL9 timing matches system spec
  • 5 V unbuffered non-ECC DIMMs fit standard slots
  • 240-pin DDR3 form factor installs without adapters

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM2566410600DIMM
Capacity4GB (2 x 2GB)
Type240-Pin DDR3 SDRAM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Timing9-9-9
Voltage1.5V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemEmachines El1352G Desktop
Package Content2 Memory RAM Sticks

Kysymyksiä tästä tuotteesta

Will the 240-pin DDR3 modules need any cleaning or replacement after long-term use?

No routine cleaning or replacement is required; the unbuffered non-ECC DIMMs have no moving parts and carry a limited lifetime warranty from Computer Memory Solutions.

What is the first limit reached when the 1333 MHz CL9 kit runs continuously at full load?

The DDR3-10600 speed rating and CL9 timing set the maximum sustained throughput; the memory controller will throttle before the modules themselves hit a thermal or electrical limit.

How much heat and power do the 1.5 V sticks produce when the eMachines EL1352G runs all day?

Each 2 GB module operates at 1.5 V without a heat spreader, so power draw stays low and passive case airflow is normally sufficient to keep temperatures in check.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.