Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR2 FB-DIMM sticks, 240-pin, no heat spreader

Computer Memory Solutions

Computer Memory Solutions 8GB (2x4GB) DDR2 5300 667MHz ECC FB-DIMM - B54

SKU CH-4P1C-W6WHR

8GB (2×4GB) DDR2 667MHz ECC fully buffered DIMM kit for Dell PowerEdge SC1430 servers

  • Capacity8GB (2 x 4GB)
  • Type240-Pin DDR2 SDRAM
  • SpeedDDR2 667 (PC2 5300)
  • CAS LatencyCL5
  • Timing5-5-5
  • Voltage1.8V
  • ECC protection safeguards data integrity on the Dell PowerEdge SC1430
  • Fully buffered architecture stabilises signals for reliable server operation
  • DDR2-667 speed matches the system memory bus for correct timing
  • 2x4GB kit fills two slots to reach 8GB total capacity
  • 240-pin form factor fits the SC1430 memory sockets exactly

Fully Buffered DDR2 for Dell PowerEdge SC1430

This 8 GB kit supplies two 4 GB DDR2-667 fully buffered ECC modules built for the Dell PowerEdge SC1430 server. The 240-pin FB-DIMMs run at 1.8 V with CL5 timing and a 2Rx4 organisation. They are intended for administrators upgrading or repairing that specific platform.

Replaces lower-capacity

The server supports up to 16 GB across four sockets, so this kit fills half the maximum configuration. The jump is worthwhile when the system currently runs with 4 GB or less, or when existing modules show errors and ECC protection is required for data integrity.

Verify FB-DIMM slots and DDR2 requirement before

The PowerEdge SC1430 accepts only fully buffered DDR2 memory; standard registered or unbuffered DDR2 will not function. Confirm the server has free 240-pin FB-DIMM slots and that the BIOS is current enough to recognise 4 GB ranks. This kit is not suitable for any desktop or non-FB-DIMM platform.

Kohokohdat

  • ECC protection safeguards data integrity on the Dell PowerEdge SC1430
  • Fully buffered architecture stabilises signals for reliable server operation
  • DDR2-667 speed matches the system memory bus for correct timing
  • 2x4GB kit fills two slots to reach 8GB total capacity
  • 240-pin form factor fits the SC1430 memory sockets exactly

Tekniset tiedot

BrandComputer Memory Solutions
ModelCM512725300FBDIMM
Capacity8GB (2 x 4GB)
Type240-Pin DDR2 SDRAM
SpeedDDR2 667 (PC2 5300)
CAS LatencyCL5
Timing5-5-5
Voltage1.8V
ECCYes
Buffered/RegisteredFully Buffered
Rank2Rx4
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemDell Poweredge Sc1430
Package Content2 Memory RAM Sticks

Kysymyksiä tästä tuotteesta

Will the 240-pin DDR2 FB-DIMM modules fit the Dell PowerEdge SC1430 memory slots?

Yes, the 240-pin fully buffered DDR2 DIMMs are built for the SC1430's four registered memory sockets and will seat correctly in each slot.

What is the correct order for installing the two 4 GB sticks in the SC1430?

Populate the lowest-numbered sockets first, typically DIMM 1 and DIMM 2, so the memory controller initialises both channels in the proper sequence.

When should the ECC FB-DIMM kit be replaced in a Dell PowerEdge SC1430?

Replace the modules if the server logs correctable ECC errors that become uncorrectable, or if diagnostics report a persistent failure on either 4 GB stick.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.