NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
Kingston Technology Corp.
8 GB DDR4 2133 ECC unbuffered DIMM with CL15 timing and 1.2 V operation for compatible servers and workstations
This 8 GB DDR4 module runs at 2133 MHz with CL15 timings and 1.20 V operation. It provides ECC error correction in an unbuffered 288‑pin DIMM format. The dual‑rank 2Rx8 organisation suits workstations and entry‑level servers that require data integrity. Kingston ValueRAM branding indicates standard validated reliability.
Buyers needing registered or load‑reduced modules cannot use this stick. Systems limited to non‑ECC memory will not benefit from the error‑correction feature. Builds requiring capacities above 8 GB per slot or speeds beyond 2133 MHz should select different modules.
The combination of unbuffered signalling and on‑die ECC is the decisive attribute for motherboard compatibility. Only boards that explicitly support unbuffered ECC DDR4 at 2133 MHz will POST correctly with this part. Verify the platform memory qualification list before ordering.
| Brand | Kingston |
|---|---|
| Series | ValueRAM |
| Model | KVR21E15D8/8HA |
| Capacity | 8GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Timing | 15-15-15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Features | Power Supply: VDD = 1.2V Typical VDDQ = 1.2V Typical VPP - 2.5V Typical VDDSPD = 2.2V to 3.6V Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals Low-power auto self refresh (LPASR) Data bus inversion (DBI) for data bus On-die VREFDQ generation and calibration Dual-rank On-board I2 serial presence-detect (SPD) EEPROM Temperature sensor with integrated SPD 16 internal banks; 4 groups of 4 banks each Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS) Selectable BC4 or BL8 on-the-fly (OTF) Fly-by topology Terminated control |
| Lähetyspaino | 0.03 kg |
| Pakkauksen mitat | 146 × 46 × 8 mm |
The module runs at 2133 MHz, delivering up to PC4 17000 bandwidth for workloads that can use that throughput.
The 288-pin DDR4 connection caps transfer rate at 2133 MHz, so faster CPUs or chipsets cannot push this memory beyond that speed.
It requires a standard 288-pin DDR4 DIMM slot and enough vertical clearance for a module without a heat spreader.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?