Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green circuit board with gold connectors and mounting holes

LORDWORLD

LORDWORLD CM4 Interface Protection Adapter Board

SKU CH-QXXS-P2KRY

Protects the Raspberry Pi CM4 socket from wear during repeated module swaps

  • Protects CM4 socket from wear during frequent module swaps
  • Extends connector lifespan by absorbing repeated insertion force
  • Maintains reliable electrical contact across many connection cycles
  • Designed specifically for Raspberry Pi Compute Module 4 series
  • Enables rapid development workflows needing constant module changes

CM4 Interface Protection Adapter

The LORDWORLD adapter board serves as a physical shield for the Raspberry Pi Compute Module 4 socket. It is designed for developers and engineers who repeatedly swap modules during prototyping or testing. The HAT format ensures direct compatibility with the CM4 form factor. This accessory targets workflows where connector wear is a practical concern.

Replaces Direct Socket Wear

Instead of plugging the Compute Module 4 directly into a carrier board, this adapter absorbs the mechanical stress of repeated insertion cycles. It is worth adopting when a project demands daily module changes for firmware validation or hardware bring-up. The board prevents bent pins and socket degradation on the more expensive carrier hardware. It suits any CM4-series module without modification.

Sustained Insertion Cycles

Under continuous development schedules the adapter maintains reliable electrical contact across hundreds of mating cycles. Gold-plated contacts resist oxidation that can accumulate during long test campaigns. The rigid PCB construction prevents flex that might misalign pins during rapid swaps. No active cooling or power management is required for the adapter itself.

Kohokohdat

  • Protects CM4 socket from wear during frequent module swaps
  • Extends connector lifespan by absorbing repeated insertion force
  • Maintains reliable electrical contact across many connection cycles
  • Designed specifically for Raspberry Pi Compute Module 4 series
  • Enables rapid development workflows needing constant module changes

Tekniset tiedot

BrandLORDWORLD

Kysymyksiä tästä tuotteesta

What form factor does the LORDWORLD CM4 adapter board use so it fits my Raspberry Pi Compute Module 4?

The board is built as a HAT that aligns with the standard Raspberry Pi Compute Module 4 footprint, matching the module's mounting holes and 40-pin GPIO header spacing for direct stacking.

How do I install the adapter without damaging the CM4 socket during repeated insertions?

Seat the Compute Module 4 vertically into the adapter's socket first, then press the combined assembly onto the carrier board's GPIO header; forcing the module in at an angle bends the socket pins.

Which parts wear out first if I swap Compute Module 4 units daily, and can they be replaced?

The high-cycle CM4 socket on the adapter is the primary wear item; it is surface-mounted, so replacing it requires hot-air rework rather than a simple plug-in swap.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.