Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green DDR5 RDIMM circuit board with gold contacts and black memory chips

NEMIX RAM

NEMIX RAM 128GB DDR5 5600MHz PC5-44800 2Rx4 CL46 1.1V ECC Registered RDIMM Supermicro H13DSG-OM memory upgrade

SKU CH-835A-493RE

128 GB DDR5 5600 MHz registered ECC RDIMM validated for the Supermicro H13DSG-OM motherboard

  • Capacity128GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 128GB

Näytä 30 muuta kokoonpanoa
  • 128 GB DDR5 capacity scales demanding server workloads with 128 GB per module
  • DDR5 5600 MT/s speed delivers rated throughput at PC5-44800 bandwidth
  • Registered ECC architecture with CL46 timing corrects single-bit errors for production stability
  • 2Rx4 dual-rank organisation and 1.10 V operation match the Supermicro H13DSG-OM memory controller exactly
  • 288-pin RDIMM form factor fits the board's required registered DIMM slots without adapters

Target Server Upgrade

This 128GB DDR5 RDIMM is built for administrators expanding a Supermicro H13DSG-OM motherboard. The registered ECC design supports fully populated slots at rated speed while correcting single-bit errors to protect production workloads.

Critical Specification Match

The module operates at 5600MHz PC5-44800 with a CL46 latency and 1.1V voltage in a 2Rx4 rank configuration. This exact combination of speed, timing, voltage and rank is required for the memory controller to recognize the full capacity and run without downclocking.

Thermals and Power

Running at the standard 1.10V DDR5 voltage keeps power draw low per module. The lack of a heat spreader means airflow across the bare PCB is necessary to maintain stable temperatures when all slots are populated under sustained load.

Not for non-ECC platforms

Builders using consumer motherboards that accept only unbuffered non-ECC UDIMMs cannot use this registered module; the different pin signalling and command protocol will prevent the system from posting.

Kohokohdat

  • 128 GB DDR5 capacity scales demanding server workloads with 128 GB per module
  • DDR5 5600 MT/s speed delivers rated throughput at PC5-44800 bandwidth
  • Registered ECC architecture with CL46 timing corrects single-bit errors for production stability
  • 2Rx4 dual-rank organisation and 1.10 V operation match the Supermicro H13DSG-OM memory controller exactly
  • 288-pin RDIMM form factor fits the board's required registered DIMM slots without adapters

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-724K1
Capacity128GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content128GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Will the DDR5 5600 speed run at full rate once installed in the Supermicro H13DSG-OM?

The module is an exact-match upgrade specified at DDR5 5600 (PC5-44800) with CL46 timing and 1.10 V, so the memory controller recognises it at full capacity and rated speed.

Does the 288-pin RDIMM form factor and registered ECC design match what the H13DSG-OM motherboard requires?

Yes — this is a 288-pin DDR5 RDIMM with registered (buffered) architecture and ECC, the precise form factor and error-correction the board expects for fully populated slots.

What physical clearance does the module need since it has no heat spreader?

The bare 288-pin RDIMM PCB fits the standard DDR5 DIMM slot height on the H13DSG-OM; verify your chassis or CPU cooler allows the normal module profile before installing.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.