Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM 128GB DDR5 6400MHz PC5-51200 4Rx4 1.1V CL52 288-PIN ECC RDIMM memory upgrade

SKU CH-9V0G-S5KJQ

128GB DDR5 6400MHz registered ECC server module with 4Rx4 rank, CL52 latency, 1.1V operation, and 288-pin RDIMM form factor validated for Supermicro X14SDW-42C-SP9F motherboards

  • Capacity128GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes
  • 128 GB capacity for high-density server workloads
  • DDR5 6400 speed rated at PC5-51200 bandwidth
  • CL52 latency at 1.1 V operating voltage
  • 4Rx4 registered ECC architecture for error correction
  • 288-pin RDIMM form factor matches Supermicro X14SDW-42C-SP9F

Exact-fit server memory

This 128GB DDR5 6400MHz PC5-51200 4Rx4 1.1V CL52 288-pin ECC RDIMM is built for the Supermicro X14SDW-42C-SP9F motherboard. The registered architecture and ECC function match the board's memory controller requirements so every slot can be populated at the rated speed.

Replacing slower or smaller modules

Upgrade from lower-capacity DDR5 RDIMMs when your workload needs the full 128GB per module at 6400MHz without down-clocking. The jump is worth it when the manual confirms this exact rank, voltage and timing combination for full population.

Build integration

The 288-pin RDIMM form factor fits the Supermicro X14SDW-42C-SP9F memory slots directly — no UDIMM or SODIMM alternative will seat correctly. Registered buffering offloads the memory controller, freeing electrical margin for dense population across all channels.

Kohokohdat

  • 128 GB capacity for high-density server workloads
  • DDR5 6400 speed rated at PC5-51200 bandwidth
  • CL52 latency at 1.1 V operating voltage
  • 4Rx4 registered ECC architecture for error correction
  • 288-pin RDIMM form factor matches Supermicro X14SDW-42C-SP9F

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-744K1
Capacity128GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank4Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content128GB DDR5 6400MHz PC5-51200 4Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Will this 288-pin DDR5 RDIMM fit the memory slots on my Supermicro X14SDW-42C-SP9F motherboard?

Yes, the module uses the 288-pin RDIMM form factor required by that board. It is not a UDIMM or SODIMM, so it matches the slot keying and electrical interface exactly.

What is the correct installation sequence for this 4Rx4 registered ECC module on the X14SDW-42C-SP9F?

Consult the motherboard manual for the approved DIMM population order. Registered modules must be installed in the specific slot sequence the board expects, otherwise the system will not recognise the full 128 GB capacity.

Does the lack of a heat spreader on this 1.1 V DDR5 module mean I need to add active cooling later?

The module runs at the standard 1.1 V DDR5 voltage without a spreader. In a server chassis with normal airflow this is sufficient; additional cooling is only needed if your enclosure restricts air movement over the DIMM slots.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.