Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR5 RDIMM modules, no heat spreaders, 288-pin edge connectors, 192GB kit

NEMIX RAM

NEMIX RAM 192GB (2 x 96GB) DDR5 4800 CL40 ECC Registered RDIMM memory upgrade for Supermicro H14SST-G

SKU CH-172V-BP8K6

192 GB DDR5-4800 ECC Registered RDIMM kit (2 × 96 GB, CL40, 1.1 V) validated for Supermicro H14SST-G motherboards

  • Capacity192GB (2 x 96GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 192GB 2X96GB

Näytä 30 muuta kokoonpanoa
  • 192 GB total capacity from two 96 GB modules
  • DDR5 4800 speed with CL40 latency for rated performance
  • Registered ECC design prevents data corruption under load
  • 2Rx4 organisation matches Supermicro H14SST-G population rules
  • 1 V operation meets server power-efficiency requirements

192 GB DDR5 ECC RDIMM kit for Supermicro H14SST-G

This 192 GB kit contains two 96 GB DDR5 4800 registered ECC RDIMMs built to the exact rank, voltage and timing the Supermicro H14SST-G motherboard expects. It targets administrators who need maximum registered capacity in a validated two-module configuration for production servers.

Thermals and power in normal use

Each module operates at 1.1 V without a heat spreader, relying on the server chassis airflow for cooling. Registered buffering reduces electrical load on the memory controller so all slots can run fully populated at rated speed, while ECC corrects single-bit errors to prevent silent data corruption.

The specification that decides fit

The motherboard requires 288-pin DDR5 RDIMMs; UDIMM or SODIMM modules will not fit or function. Verify your system manual for supported capacities and approved population order before installation.

Kohokohdat

  • 192 GB total capacity from two 96 GB modules
  • DDR5 4800 speed with CL40 latency for rated performance
  • Registered ECC design prevents data corruption under load
  • 2Rx4 organisation matches Supermicro H14SST-G population rules
  • 1 V operation meets server power-efficiency requirements

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-9624K2
Capacity192GB (2 x 96GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content192GB 2X96GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How do I install the 288-pin DDR5 RDIMM modules in the Supermicro H14SST-G and which slot order do people often get wrong?

Power down the server, open the chassis, and insert each 96GB module into the DIMM slots following the population sequence shown in the Supermicro H14SST-G manual; the most common mistake is skipping the prescribed order, which prevents the 192GB kit from being recognised at full capacity.

What maintenance or replacement will the 2Rx4 Registered ECC RDIMM kit need during its service life?

The modules have no moving parts or heat spreaders, so no routine maintenance is required; if a single-bit error exceeds ECC correction or a module fails, replace the affected 96GB stick — the kit is covered by a lifetime replacement warranty.

What is the first limit that appears when the 192GB DDR5-4800 CL40 kit runs sustained workloads on the H14SST-G?

The memory controller is locked to 4800 MT/s at 1.1 V with CL40 latency, so sustained throughput cannot exceed the rated PC5-38400 bandwidth; thermal throttling is unlikely without a heat spreader, but the speed ceiling is the primary bottleneck.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.