Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Six green DDR5 RDIMM modules in a row

NEMIX RAM

NEMIX RAM 288GB 6x48GB DDR5 4800 CL40 ECC RDIMM GIGABYTE MZ73-LM2 memory upgrade

SKU CH-NSZ2-TQV7Q

A 288 GB registered ECC DDR5 kit with six 48 GB modules at 4800 MT/s, CL40 and 1.1 V, built for the GIGABYTE MZ73-LM2 motherboard

  • Capacity288GB (6 x 48GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 288GB 6X48GB

Näytä 18 muuta kokoonpanoa
  • 288 GB total capacity from six 48 GB modules for maximum server density
  • DDR5 4800 speed with CL40 latency delivers rated bandwidth out of the box
  • Registered ECC architecture corrects single-bit errors and offloads the memory controller
  • 1 V operation matches the motherboard's voltage requirement exactly
  • Verified compatibility with the GIGABYTE MZ73-LM2 motherboard ensures correct population

GIGABYTE MZ73-LM2 DDR5 ECC RDIMM Kit

This 288GB kit contains six 48GB DDR5 4800 Registered ECC RDIMMs built for the GIGABYTE MZ73-LM2 motherboard. It targets server administrators who need maximum capacity across all channels with hardware error correction. The 2Rx8 organisation and 1.1V operation match the board's memory-controller requirements exactly.

Replacing partial or mismatched memory

Upgrading from smaller RDIMMs or mixed-rank modules lets the controller run every slot at the rated 4800 speed without down-clocking. The jump is worth it when workloads demand the full 288GB address space and registered buffering to keep signal integrity at full population. It does not suit builds that only need consumer UDIMM densities or non-ECC operation.

Tool-free DIMM installation

Modules seat in the 288-pin RDIMM slots using the board's standard ejection levers; no heat spreader clearance checks are required. What usually goes wrong is ignoring the manual's population sequence, which can leave capacity unrecognised or force a lower data rate. Verify the approved slot order before powering on.

Kohokohdat

  • 288 GB total capacity from six 48 GB modules for maximum server density
  • DDR5 4800 speed with CL40 latency delivers rated bandwidth out of the box
  • Registered ECC architecture corrects single-bit errors and offloads the memory controller
  • 1 V operation matches the motherboard's voltage requirement exactly
  • Verified compatibility with the GIGABYTE MZ73-LM2 motherboard ensures correct population

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-4828K6
Capacity288GB (6 x 48GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content288GB 6X48GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the 288-pin RDIMM form factor match the DIMM slots on the GIGABYTE MZ73-LM2 motherboard?

Yes, the kit uses the 288-pin DDR5 RDIMM form factor required by the GIGABYTE MZ73-LM2 motherboard; it is not a UDIMM or SODIMM, so it fits the server's registered DIMM slots.

What is the correct population order for installing all six 48GB modules on the GIGABYTE MZ73-LM2 motherboard?

Consult the GIGABYTE MZ73-LM2 motherboard manual for the approved DIMM population sequence; the six 2Rx8 Registered ECC modules must be installed in the specific slot order the manual defines to run at DDR5-4800 CL40.

Will the Samsung, Micron, or Hynix DRAM chips on these modules require any firmware updates or maintenance over time?

No firmware updates are needed for the DRAM chips; the modules run at 1.1V with on-die ECC correction, and the only long-term step is reseating the 288-pin RDIMMs if the server is moved or vibrated heavily.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.