Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Six green DDR5 RDIMM modules in a row

NEMIX RAM

NEMIX RAM 288GB 6x48GB DDR5 4800 CL40 ECC RDIMM GIGABYTE MZ73-LM2 memory upgrade

SKU CH-NSZ2-TQV7Q

A 288 GB registered ECC DDR5 kit with six 48 GB modules at 4800 MT/s, CL40 and 1.1 V, built for the GIGABYTE MZ73-LM2 motherboard

  • Capacity288GB (6 x 48GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 288GB 6X48GB

Zobrazit dalších 18 konfigurací
  • 288 GB total capacity from six 48 GB modules for maximum server density
  • DDR5 4800 speed with CL40 latency delivers rated bandwidth out of the box
  • Registered ECC architecture corrects single-bit errors and offloads the memory controller
  • 1 V operation matches the motherboard's voltage requirement exactly
  • Verified compatibility with the GIGABYTE MZ73-LM2 motherboard ensures correct population

GIGABYTE MZ73-LM2 DDR5 ECC RDIMM Kit

This 288GB kit contains six 48GB DDR5 4800 Registered ECC RDIMMs built for the GIGABYTE MZ73-LM2 motherboard. It targets server administrators who need maximum capacity across all channels with hardware error correction. The 2Rx8 organisation and 1.1V operation match the board's memory-controller requirements exactly.

Replacing partial or mismatched memory

Upgrading from smaller RDIMMs or mixed-rank modules lets the controller run every slot at the rated 4800 speed without down-clocking. The jump is worth it when workloads demand the full 288GB address space and registered buffering to keep signal integrity at full population. It does not suit builds that only need consumer UDIMM densities or non-ECC operation.

Tool-free DIMM installation

Modules seat in the 288-pin RDIMM slots using the board's standard ejection levers; no heat spreader clearance checks are required. What usually goes wrong is ignoring the manual's population sequence, which can leave capacity unrecognised or force a lower data rate. Verify the approved slot order before powering on.

Přednosti

  • 288 GB total capacity from six 48 GB modules for maximum server density
  • DDR5 4800 speed with CL40 latency delivers rated bandwidth out of the box
  • Registered ECC architecture corrects single-bit errors and offloads the memory controller
  • 1 V operation matches the motherboard's voltage requirement exactly
  • Verified compatibility with the GIGABYTE MZ73-LM2 motherboard ensures correct population

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-4828K6
Capacity288GB (6 x 48GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content288GB 6X48GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Does the 288-pin RDIMM form factor match the DIMM slots on the GIGABYTE MZ73-LM2 motherboard?

Yes, the kit uses the 288-pin DDR5 RDIMM form factor required by the GIGABYTE MZ73-LM2 motherboard; it is not a UDIMM or SODIMM, so it fits the server's registered DIMM slots.

What is the correct population order for installing all six 48GB modules on the GIGABYTE MZ73-LM2 motherboard?

Consult the GIGABYTE MZ73-LM2 motherboard manual for the approved DIMM population sequence; the six 2Rx8 Registered ECC modules must be installed in the specific slot order the manual defines to run at DDR5-4800 CL40.

Will the Samsung, Micron, or Hynix DRAM chips on these modules require any firmware updates or maintenance over time?

No firmware updates are needed for the DRAM chips; the modules run at 1.1V with on-die ECC correction, and the only long-term step is reseating the 288-pin RDIMMs if the server is moved or vibrated heavily.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.