Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green 288-pin DDR5 RDIMM sticks in anti-static tray

NEMIX RAM

NEMIX RAM 32GB (2x16GB) DDR5-6400 CL52 1.1V ECC Registered RDIMM for GIGABYTE MZ33-CP1

SKU CH-KD7G-TQSMQ

32 GB dual-rank DDR5-6400 ECC registered RDIMM kit validated for GIGABYTE MZ33-CP1 servers

  • Capacity32GB (2 x 16GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes

Size 32GB 2X16GB

Näytä 24 muuta kokoonpanoa
  • 32 GB capacity in a 2 x 16 GB kit for full dual-channel bandwidth
  • DDR5-6400 speed with CL52 latency delivers rated throughput for the MZ33-CP1
  • Registered ECC design corrects single-bit errors and supports full-slot population
  • 10 V operation matches the board's memory-controller specification exactly
  • 288-pin RDIMM form factor ensures physical and electrical compatibility with the server motherboard

Exact-fit DDR5 kit for GIGABYTE MZ33-CP1

This 32 GB kit contains two 16 GB DDR5-6400 Registered ECC RDIMMs built to the GIGABYTE MZ33-CP1 motherboard's validated specification. The 1Rx8 rank, 1.1 V operation and CL52 timing match the memory controller's expectations so the system recognises full capacity at rated speed. It is intended for administrators upgrading or populating this specific server platform.

Installation is a standard 288-pin RDIMM insertion

Align the module key with the slot, press evenly until the retention clips engage, then follow the motherboard manual's population order for the number of modules installed. The most common issue is mixing Registered RDIMMs with Unbuffered UDIMMs or SODIMMs, which the board does not support and will prevent boot. Verify the approved DIMM sequence in the manual before adding more modules.

Registered ECC with 1Rx8 organisation

The Registered (buffered) architecture offloads the memory controller, allowing every populated slot to run at full capacity while on-die ECC corrects single-bit errors in flight. This combination of registration, ECC and single-rank 1Rx8 organisation is the single specification that determines whether the kit will operate correctly on the MZ33-CP1 platform.

Kohokohdat

  • 32 GB capacity in a 2 x 16 GB kit for full dual-channel bandwidth
  • DDR5-6400 speed with CL52 latency delivers rated throughput for the MZ33-CP1
  • Registered ECC design corrects single-bit errors and supports full-slot population
  • 10 V operation matches the board's memory-controller specification exactly
  • 288-pin RDIMM form factor ensures physical and electrical compatibility with the server motherboard

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-618K2
Capacity32GB (2 x 16GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content32GB 2X16GB DDR5 6400MHz PC5-51200 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How can I confirm the kit runs at DDR5-6400 CL52 after installing it in my GIGABYTE MZ33-CP1?

Enter the BIOS and verify the memory frequency reads 6400 MT/s with timings at 52-52-52 and voltage at 1.10 V; the registered ECC design ensures the board recognises both 16 GB modules at full speed.

What exactly ships in the box and is anything else required for installation?

The package contains two 16 GB 288-pin DDR5 RDIMMs — 32 GB total — with no heat spreaders; no extra cables, brackets or software are needed, just an available RDIMM slot on the motherboard.

Why choose this 32 GB 2x16 GB DDR5-6400 CL52 kit over other capacities for the MZ33-CP1?

This exact-match 2x16 GB registered ECC kit meets the board's 1Rx8 rank, 1.1 V voltage and CL52 timing requirements, allowing full population at the rated 6400 MT/s without down-clocking.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.