NEMIX RAM 32GB (2×16GB) DDR5 5600 CL46 1.1V UDIMM Supermicro X14SAE
- 32GB (2 x 16GB)
- 288-Pin DDR5 UDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
NEMIX RAM
A 32 GB DDR5 5600 MHz UDIMM with CL46 latency, 1.1 V operation and 2Rx8 rank, built from major OEM chips and validated for the Supermicro X14SAE motherboard
Size 32GB
This 32GB DDR5 module is built to the precise rank, voltage and timing the X14SAE memory controller expects. It installs as a 288-pin UDIMM and is recognised at full capacity without manual configuration.
Operating at 1.10V, the module draws minimal power and produces no audible noise. Without a heat spreader it relies on case airflow, so normal chassis ventilation keeps temperatures within specification during typical workloads.
The single 32GB DIMM upgrades one slot to the board's rated 5600MHz speed and CL46 latency. It does not add ECC, registered buffering or RGB lighting, and it leaves remaining slots free for further expansion within the motherboard's population rules.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Memory |
| Model | DDR5 Non-ECC Unbuffered UDIMM Memory |
| Part Number | MD44800-328K1 |
| Capacity | 32GB |
| Type | 288-Pin DDR5 UDIMM |
| Speed | DDR5 5600 (PC5 44800) |
| CAS Latency | CL46 |
| Voltage | 1.10V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Heat Spreader | No |
| Compatible System | Supermicro |
| Features | DDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible |
| Package Content | 32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN Non-ECC UDIMM KIT |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Align the notch on the 288-pin DDR5 UDIMM with the slot key, press down until both side clips click, then verify in BIOS that the module is recognised at 5600 MHz and 1.10 V; the step often missed is checking the motherboard manual for the correct DIMM population order before fitting the 32 GB stick.
No scheduled maintenance is required for the non-ECC unbuffered UDIMM; if a memory error appears, run a memtest and replace the module under the lifetime replacement warranty.
The CAS latency of CL46 at 1.10 V sets the timing ceiling; sustained workloads will hit this latency boundary before any thermal throttle because the module has no heat spreader.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?