Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM 64GB (4×16GB) DDR5 5600 CL46 1.1V 288-pin UDIMM Kit for Supermicro X13SAE

SKU CH-D75D-WEAHQ

64 GB kit of four 16 GB DDR5-5600 CL46 1.1 V 288-pin UDIMM modules validated for the Supermicro X13SAE motherboard

  • Capacity64GB (4 x 16GB)
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo
  • 64 GB total capacity from four 16 GB modules for memory-intensive workloads
  • DDR5-5600 speed with PC5-44800 rating delivers rated throughput on supported boards
  • CL46 CAS latency at 1.10 V matches the controller's expected timing and voltage
  • 288-pin UDIMM form factor fits the Supermicro X13SAE motherboard's memory slots
  • Built with Samsung, Micron or Hynix OEM chips and tested for stability at rated specs

64GB DDR5 kit for Supermicro X13SAE

This 64GB kit contains four 16GB DDR5 modules rated at 5600MHz with CL46 latency and 1.1V operation. It is built as an exact-match upgrade for the Supermicro X13SAE motherboard using 288-pin unbuffered UDIMM form factor.

DDR5 5600 platform limits

DDR5 5600 (PC5-44800) is the maximum JEDEC standard speed this memory controller supports without overclocking. The four-module population fills every slot on the board, so no further capacity can be added later.

1Rx8 rank and 1.1V requirement

The memory controller expects 1Rx8 organisation at 1.1V; modules with different rank structure or voltage will not be recognised at full capacity or rated speed. Builders who need ECC, registered DIMMs, or higher density per module cannot use this kit.

Kohokohdat

  • 64 GB total capacity from four 16 GB modules for memory-intensive workloads
  • DDR5-5600 speed with PC5-44800 rating delivers rated throughput on supported boards
  • CL46 CAS latency at 1.10 V matches the controller's expected timing and voltage
  • 288-pin UDIMM form factor fits the Supermicro X13SAE motherboard's memory slots
  • Built with Samsung, Micron or Hynix OEM chips and tested for stability at rated specs

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-618K4
Capacity64GB (4 x 16GB)
Type288-Pin DDR5 UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content64GB 4X16GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Should I buy the 64GB kit as 4×16GB modules or look for a different capacity?

The kit provides exactly 64GB total across four 16GB modules, filling four UDIMM slots on the Supermicro X13SAE motherboard.

Will the DDR5 5600 CL46 rating actually run at that speed once installed in the X13SAE?

The modules are tested at DDR5 5600 with CL46 timings and 1.10V, so the board recognises them at full rated speed without manual tuning.

Does the 288-pin UDIMM interface limit bandwidth or compatibility on this motherboard?

The 288-pin unbuffered DDR5 form factor matches the X13SAE slots; the PC5-44800 designation confirms the rated data rate for this platform.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.