Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Six green circuit boards with black chips, no heat spreaders, 288 gold pins each

NEMIX RAM

NEMIX RAM 96GB (6x16GB) DDR5 4800MHz CL40 1Rx8 1.1V 288-Pin ECC Registered RDIMM Kit for GIGABYTE MZ33-AR1

SKU CH-FR0N-SSGRF

A 96GB DDR5 ECC Registered RDIMM kit of six 16GB modules at 4800MHz CL40, validated for the GIGABYTE MZ33-AR1 motherboard

  • Capacity96GB (6 x 16GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 96GB 6X16GB

Näytä 18 muuta kokoonpanoa
  • 96 GB capacity across six 16 GB modules for high-density server workloads
  • DDR5 4800 MT/s speed delivers rated bandwidth for GIGABYTE MZ33-AR1
  • Registered ECC architecture corrects single-bit errors to prevent data corruption
  • 10 V operation at CL40 latency matches the board's memory controller spec
  • 288-pin RDIMM form factor fits the required slots for full population

96GB DDR5 ECC RDIMM Kit for GIGABYTE MZ33-AR1

This 96GB kit contains six 16GB DDR5 4800MHz registered ECC modules built for the GIGABYTE MZ33-AR1 motherboard. It targets server administrators who need exact-match memory that the board's controller recognises at full capacity and rated speed. Each RDIMM runs at 1.1V with CL40 timing and a 1Rx8 organisation, matching the platform's native DDR5 4800 specification.

Registered DIMM installation and common pitfalls

Install the 288-pin RDIMMs only in the slots and population order listed in the MZ33-AR1 manual; the registered architecture offloads the memory controller so every slot can run fully populated. A frequent error is mixing these registered ECC modules with unbuffered UDIMMs or SODIMMs, which the board will not accept. Another issue is skipping the manual's population sequence, which can prevent the system from booting or recognising the full 96GB capacity.

Pre-order checks for your MZ33-AR1 setup

Verify that your motherboard revision supports 96GB total capacity and confirm the approved DIMM population order for a six-module configuration. Ensure the BIOS version installed meets the board's memory-support requirements for DDR5 4800 registered ECC. Check that no UDIMM or SODIMM modules are currently installed, because registered and unbuffered types cannot be mixed on this platform.

Kohokohdat

  • 96 GB capacity across six 16 GB modules for high-density server workloads
  • DDR5 4800 MT/s speed delivers rated bandwidth for GIGABYTE MZ33-AR1
  • Registered ECC architecture corrects single-bit errors to prevent data corruption
  • 10 V operation at CL40 latency matches the board's memory controller spec
  • 288-pin RDIMM form factor fits the required slots for full population

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-618K6
Capacity96GB (6 x 16GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemGIGABYTE
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content96GB 6X16GB DDR5 4800MHz PC5-38400 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How do I confirm the kit is running at DDR5 4800 with CL40 after installation?

Enter the BIOS or use a tool like CPU-Z and verify the memory frequency reads 4800 MT/s and the CAS latency shows 40; the registered ECC design ensures the MZ33-AR1 recognises all 96 GB at the rated speed.

What does the 96 GB kit contain and is anything else required?

The box holds six 16 GB DDR5 288-pin RDIMMs (part MR38400-618K6) with Samsung, Micron or Hynix chips; no heat spreaders, cables or additional parts are included or needed.

Why choose this 6 × 16 GB registered ECC kit instead of a smaller or unbuffered alternative?

The MZ33-AR1 requires registered RDIMMs; this exact-match 96 GB kit provides 1Rx8 organisation at 1.10 V so every slot can be populated at full capacity with ECC error correction.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.